104LSQT1394Helpful hints3 TroubleshootingProblem Check pointsThis unit cannot beturned on.This unit does not stayon long enough.Battery runs downquickly.≥ Charge the battery using the AC adaptor. (l 18)≥ The battery protection circuit may have operated. Attachthe battery to the AC adaptor for 5 to 10 seconds. If the unitstill cannot be used, the battery is faulty.≥ Make sure the LCD monitor is opened.≥ The battery is affected by ambient temperature. In coldplaces, the battery using time becomes shorter.≥ The battery has a limited life. If the operating time is still tooshort even after the battery is fully charged, the battery hasworn out and needs to be replaced.This unit is turned offautomatically.≥ If you do not use the unit for approximately 5 minutes, thepower is automatically turned off to conserve battery life. Toresume recording, turn the power back on.The power will not turn off automatically when the powersave function (l 29) is set to [OFF].This unit cannot beoperated though it isturned on.This unit does notoperate normally.≥ The unit cannot be operated unless you open the LCDmonitor.≥ Remove the SD card then press the RESET button.(l 107) If normal conditions are not restored yet, removethe battery or AC adaptor, wait about 1 minute and thenreconnect the battery or AC adaptor. Then about 1 minutelater, turn on the power again. (Conducting the aboveoperation when the access lamp is on may destroy the dataon the HDD or the SD card.)A clicking sound is heardwhen the power is turnedoff.≥ This is the sound of the lens moving and is not amalfunction.The screen has changedsuddenly.(Demo mode is on)≥ If you set [DEMO MODE] to [ON] without inserting an SDcard in video recording mode or picture recording mode,the unit is automatically set to the demonstration mode forintroducing its functions. Normally this should be set to[OFF]. (l 30)
