96LSQT1319Helpful hints3 TroubleshootingProblem Check pointsThis unit cannot beturned on.This unit does not stayon long enough.Battery runs downquickly.≥ Charge the battery using the AC adaptor. (l 18)≥ The battery protection circuit may have operated. Attachthe battery to the AC adaptor for 5 to 10 seconds. If the unitstill cannot be used, the battery is faulty.≥ Make sure the LCD monitor is opened or the viewfinderextended.≥ The battery is affected by ambient temperature. In coldplaces, the battery using time becomes shorter.≥ The battery has a limited life. If the operating time is still tooshort even after the battery is fully charged, the battery hasworn out and needs to be replaced.This unit is turned offautomatically.≥ If you do not use the unit for approximately 5 minutes, thepower is automatically turned off to conserve battery life. Toresume recording, turn the power back on.The power will not turn off automatically when the powersave function (l 31) is set to [OFF].This unit cannot beoperated though it isturned on.This unit does notoperate normally.≥ The unit cannot be operated unless you open the LCDmonitor or extend the viewfinder.≥ Press the RESET button. (l 99) If normal conditions arenot restored yet, remove the battery or AC adaptor, waitabout 1 minute and then reconnect the battery or ACadaptor. Then about 1 minute later, turn on the poweragain. (Performing the above operation when the accesslamp is on may destroy the data on the disc or SD card.)A clicking sound is heardwhen the power is turnedoff.≥ This is the sound of the lens moving and is not amalfunction.The screen has changedsuddenly.(Demo mode is on.)≥ If you set [DEMO MODE] to [ON] without inserting a disc oran SD card in video recording mode or picture recordingmode, the unit is automatically set to the demonstrationmode for introducing its functions. Normally this should beset to [OFF]. (l 32)
