Panasonic Panaboard UB-7325 Operating Instructions Manual

Also see for U1 - Toughbook - Atom Z520: Software guide Operating instructions Operating instructions Operating instructions Operating instructions

Panasonic Panaboard UB-7325 Operating Instructions Manual Manual pdf 34 page image

34Electronic Board Operations CheckAfter assembling the electronic board, perform the procedures presented in the following table to make sure itfunctions properly.* 1 Contact the store or dealer from which the unit was purchased.Step Points to CheckSymptom Solutions1 Turn on the power switch. “ ” flashes after “ ” lights up. (Normal operation)(If not) Check power cord. (See step4 on page 33.)2 Open the printer door and attach theaccessory thermal transfer film, thenclose the printer door.• Installing Thermal Transfer Filmprocedure (refer to the OperatingInstructions on page 10)“ ” flashes. (Normal operation)(If not) Check thermal transfer film.3 Open the paper cover and insertordinary Letter test paper, then closethe paper cover.• Loading Copy Paper procedure(refer to the OperatingInstructions on page 11)“ ” lights up. (Normal operation)(If not) Check copy paper.4 Open the printer door. “ ” flashes. (Normal operation)(If not) * 15 Close the printer door. “ ” lights up. (Normal operation)(If not) * 16 Press .Press .Screen is fed. (Normal operation)The screen film surface is not fedsmoothly. * 1There are strange noises.7 Use the accessory marker to drawa large filling the entirecopyable area of the screen filmsurface.• Copyable area (refer to theOperating Instructions onpage 7)Press twice.Press .“ ” lights up and three copies aremade.(Normal operation)Three copies are not made. * 1The entire readable area is notprinted.There are strange noises or paperjams during the copying process.Multiple sheets of paper are fedthrough at the same time.8 Press to move the screenfilm surface. Write letters, etc. withthe marker.Press once.Press .The Contrast/Remaining Filmindicator light is turned on and onecopy is made.(Normal operation)The Contrast/Remaining Filmindicator light is not turned on. * 1The image is not copied properly.There are strange markings on thecopy sheet(e.g., stripes or lines).9 Press once. The Contrast/Remaining Filmindicator light is turned off.(Normal operation)(If not) * 1