Part Names and Functions9Operating Instructions■ Control panelPanel Name DescriptionContrast/RemainingFilmIndicatorThis lamp indicator notifies the user when the time to replace the thermal transferfilm is approaching (estimated) and of the printing contrast used during copying.Indicator off: Normal printing contrastIndicator on: Darker than normal printing contrastIndicator flashing*: Almost time to replace the thermal transfer film(Note that only about 15 more sheets may becopied when this indicator starts flashing.)Replacement film (UG-6001) is separately availablefrom the dealer where you purchased your unit.* The flashing indicator will go out after the power is turned off, or theprinter has been opened and closed. (When copying is performed, thisindicator will begin flashing again.)ContrastKeyEach time this key is pressed, the unit will alternate between normal and darkcontrast modes (Normal/Dark).Copy Key This key causes the screen to be copied.Multi-Copy/ErrorIndicatorThis indicator displays the number of copies to be made. The display changeseach time the Multi-Copy/Stop Key is pressed.Example: 1 → 2 → ··· → 9 → →1 → ···(Selecting “ ” allows you to copy 4 screens continuously.)When an error occurred, a flashing symbol will appear in this display toindicate the error status. (See page 27.)Multi-Copy/Stop KeyWhen making multiple copies or copying 4 screens continuously, press thiskey until the desired number of copies or “ ” is displayed on the Multi-Copy/Error Indicator. This key can also be pressed to stop copying while executingmultiple copies or copying 4 screens continuously.• The display changes as shown below each time the screen is copied. Afterreaching 0, the display will reset to 1.Example for multiple copies:5 → 4 → 3 → 2 → 1 → 0 → 1 (Number is counted down.)Example for copying 4 screens continuously:→ → → → 0 → 1 (Display changes.)AdvanceKeyPressing this key advances the screen from right to left.Pressing this key twice advances two screens from right to left.Pressing this key more than 2 seconds advances the screen to the projectorscreen with no ruled lines.ReverseKeyPressing this key advances the screen from left to right.Pressing this key twice advances two screens from left to right.Pressing this key more than 2 seconds advances the screen to the projectorscreen with no ruled lines.Contrast/Remaining FilmIndicatorReverse KeyMulti-Copy/Error IndicatorMulti-Copy/Stop KeyAdvance KeyContrast KeyCopy Key