51. GENERALThis booklet briefly outlines where and how to install theair conditioning system. Please read over the entire setof instructions for the indoor and outdoor units and makesure all accessory parts listed are with the system beforebeginning.1-1. Tools Required for Installation (not supplied)1. Flathead screwdriver2. Phillips head screwdriver3. Knife or wire stripper4. Tape measure5. Carpenter’s level6. Sabre saw or keyhole saw7. Hacksaw8. Core bits9. Hammer10. Drill11. Tube cutter12. Tube flaring tool13. Torque wrench14. Adjustable wrench15. Reamer (for deburring)1-2. Accessories Supplied with UnitPart Name Figure Q’ty RemarksWasher 8 For suspension fittingFlareinsulator1 For gas pipe /liquid pipe connection1 For gas pipe /liquid pipe connectionClamper 4 For flare connectionDrain hoseinsulation 2 For drain pipeconnectionDrain hoseL=1311 For unit & PVC pipeconnectionHose band 2 For drain hoseconnectionShort-circuitconnection 1For high static pressure(Located on theback of the electricalcomponent box lid. )● Use 3/8”(M10) for suspension bolts.● Suspension bolts and nuts are field supply.1-3. Type of Copper Tube and Insulation MaterialIf you wish to purchase these materials separately from alocal source, you will need:1. Deoxidized annealed copper tube for refrigeranttubing.2. Foamed polyethylene insulation for copper tubes asrequired to precise length of tubing. Wall thickness ofthe insulation should be not less than 5/16”(8 mm).3. Use insulated copper wire for field wiring. Wire sizevaries with the total length of wiring. Refer to 4.ELECTRICAL WIRING for details.CAUTIONCheck local electrical codes and regulations beforeobtaining wire. Also, check any specified instructionsor limitations.1-4. Additional Materials Required for Installation1. Refrigeration (armored) tape2. Insulated staples or clamps for connecting wire (Seeyour local codes.)3. Putty4. Refrigeration tubing lubricant5. Clamps or saddles to secure refrigerant tubing6. Scale for weighing