Panasonic S-200PE2R5 Installation Instructions Manual

Also see for S-200PE2R5: Operating instructions

Contents

158. eXTeRNAL STATIC PReSSURe SeTTINGChoose one of the methods (selection of “a”, “b”, “c” within the range of dotted line as shown in the flowchart below)and make settings.a. No setting changes:When using as it is factory preset at shipment.(If resetting after external static pressure setting once, it might be different from factory preset.)b. Manual setting (on PCB):This is static pressure setting excepting factory preset at shipment. Dip switch select method.c. Manual setting (by timer remote controller):Static pressure setting excepting factory preset at shipment.Flow of external Static PressureNOTE(1) Refer to Tables 8-2, 8-3, 8-4 and Fig. 8-2 for details on the relationship between the value of item code “5d” andthe external static pressure.(2) When set in group control (connecting multiple indoor units with one timer remote controller), set each indoorunit to item code “5d”.When amending the setting after selecting [b. Manual setting] (due to airflow path changes, etc.), it is necessaryto cancel [b. Manual setting] (switching OFF positions).When [b. Manual setting] has not been cancelled, [c. Manual setting] will be activated if selected, but [b. Manualsetting] takes precedence when the power is switched back on after power outages, etc.CAUTION ● Make sure the external static pressure is in a range of specifications.Then proceed the external static pressure setting.Improper settings can cause noise, a shortage of airflow volume and waterleakage.Refer to Fig. 8-2 for the external static pressure setting range.● Be sure to set the [external Static Pressure Setting] once again after amendingthe airflow path for the duct or air outlet after setting the external static pressure.Start of external static pressure settingSetting of shipment : line 5Is it designedand installed at the settingline at shipment on PQ linedrawing?Refer to section 8-5.Operating bytimer remotecontrollerSelection methodsof external staticpressure settingNoNoYesYesa. No setting changesb. Manual setting(Setting on PCB)Setting switches of TP6 orTP3 or TP1Refer to section "8-1. How toset on PC Board".c. Manual settingItem code 5d : Setting 1, 3, 6(*Note 1) (*Note 2)Refer to section 8-2, 8-3 or 8-4.Completion of external static pressure setting