Panasonic SC-TMAX5 Operating Instructions Manual

Also see for SC-TMAX5: Basic operating instructions

9 TQBJ2251Wireless chargingYou can charge a Qi-compatible smartphone by placing iton the wireless charging area.The Qi and Qi logo are thetrademarks of the WirelessPower Consortium.Preparation• Switch on the unit.• Read the operating instructions of the smartphone fordetails.1 Place the smartphone with wireless chargingfunction on the marking .Move the Qi-compatible smartphone back and forth,left and right until the CHARGE indicator lights up.2 Remove the smartphone from the wirelesscharging area when it is fully charged.CHARGE indicator StateOff • Charging is complete.• The smartphone is notrecognisable by this unit.Lights up Charging a smartphone.Blinks quickly(at 0.25-secondintervals)A Charging error has occuredor there is a malfunction.Blinks slowly(at one secondintervals)Temperature of Qi-compatiblesmartphone is too high or toolow.Note:• Charging will not starts if you put the smarphone on thecharging panel when the unit is in standby mode.• Charge only one smartphone each session.• Charging stops if you move the smartphone duringcharging.• Charging may not start if the smartphone battery level is toolow.• When charging smartphone, do not make or answer calls assound may be distorted.• Remove the cover of the smartphone before placing it onthe wireless charging area.• Switch off the vibration mode before charging smartphoneto prevent them from falling. Charging may stop when thevibration intensity is strong.• Place the smartphone on the centre of the wireless chargingarea to prevent falls. Loud music playback may causevibration to the unit.• Do not charge a smartphone that is bigger than the chargingarea.• The smartphone and the surface of the charging area mightget warm after prolonged charging.• Avoid charging the smartphone outside the operatingtemperature range to prevent damage.• Avoid locations with extremely high temperatures, lowtemperatures, or high humidity. Use the product in a locationwith an ambient temperature of 10°C - 35°C and an ambienthumidity of 35% - 80%. If it is determined through aninvestigation that the product malfunctioned as a result ofuse in an environment with an extreme temperature or highhumidity, the malfunction will not be covered by the warrantyand the product will not be repaired.• When error occurs, remove the smartphone and wait for afew seconds before charging it again.• When using power bank as the power source, wirelesscharging is disabled.• If the wireless charging area is dusty, clean it using a softcloth slightly moistened with water.• The wireless charging area is a vibration absorbing softpanel. The surface sinks slightly when you press on it.