ConfidentialUntil:1 Aug 201614 RQT0B1714Using a microphonePreparationDecrease the volume of the system to its minimum beforeyou connect or disconnect a microphone.1 Connect a microphone (not supplied) to themicrophone jack.Plug type: Ø 6.3 mm monaural2 Press [MIC VOL/KARAOKE EFFECT] to select“MIC1 VOL” or “MIC2 VOL”.3 Press [Y, U] to adjust the volume of themicrophone.If you want to sing with the background music.4 Play the music source and adjust the volume ofthe system.Note:• If a strange noise (howling) is emitted, move themicrophone away from the speakers, or decrease thevolume of the microphone.• When you do not use the microphone, disconnect it fromthe microphone jack, and decrease the volume of themicrophone to its minimum.• This system cannot record from microphone.Clock and timersSetting the clockThis is a 24-hour clock.1 Press [SETUP] to select “CLOCK”.2 Press [Y, U] to set the time and then press [OK].To check the timePress [SETUP] to select “CLOCK” and then press[OK].In standby mode, press [DISPLAY].Note:Reset the clock regularly to maintain accuracy.Sleep timerThe sleep timer switches off the system after the set time.Press [SLEEP] to select the setting (in minutes).To cancel, select “OFF”.To check the remaining timePress [SLEEP].Note:• The remaining time is shown for a few seconds everyminute. “SLEEP 1” is always shown when only 1 minuteremains.• The play timer and sleep timer or the record timer and sleeptimer can be used together.• The sleep timer always comes first. Be sure not to set anoverlap of timers.Play timer and record timer(Except for Bluetooth®, D-IN, AUX 1 and AUX 2source)You can set the timer to come on at a certain time to:• Wake you up (play timer).• Record from the radio (record timer).Play timer and record timer cannot be used together.PreparationSet the clock.1 Press [SETUP] to select “TIMER ADJ”.2 Press [Y, U] to select “#PLAY” or “#REC” andthen press [OK].3 Press [Y, U] to set the start time and then press[OK].4 Do step 3 again to set the end time.5 For play timer, press [Y, U] to select the sourceyou want to play and then press [OK].6 For record timer, press [Y, U] to select “MEMORY”or “USB B” to keep the recording and then press[OK].To start the timer1 Prepare the source.2 Press [SETUP] to select “TIMER SET”.3 Press [Y, U] to select the setting and then press[OK].“#” is shown.The system must be switched off for the timer tooperate.To check the setting1 Press [SETUP] to select “TIMER ADJ”.2 Press [Y, U] to select “#PLAY” or “#REC” andthen press [OK].In standby mode, press [DISPLAY] two times.Play timer Prepare the source you want tolisten to (USB, internal memory orradio) and set the volume.Record timer Connect the USB device to USB B(for USB recording) and tune in tothe radio station.PLAY ON Start the play timer.PLAY OFF Cancel the play timer.REC ON Start the record timer.REC OFF Cancel the record timer.SC-UA7 GS RQT0B17-G En.fm Page 14 Monday, July 4, 2016 8:32 AMoffset printing