1-751. Specifications5. SELECTING THE INSTALLATION SITE5-1. Indoor UnitAVOID:areas where leakage of flammable gas may beexpected.places where large amounts of oil mist exist.direct sunlight.locations near inverter lamps which may affect theperformance of the unit.locations near heat sources which may affect theperformance of the unit.locations where external air may enter the roomdirectly. This may cause “sweating” on the air dis-charge ports, causing them to spray or drip.locations where the remote controller will be splashedwith water or affected by dampness or humidity.installing the remote controller behind curtains orfurniture.locations where the receiver in the indoor unit isexposed to the inverter lamp light. Faulty operationof the unit occurs.DO:select an appropriate position from which everycorner of the room can be uniformly cooled.select a location where the ceiling is strong enoughto support the weight of the unit.select a location where tubing and drain pipe havethe shortest run to the outdoor unit.allow room for operation and maintenance as well asunrestricted air flow around the unit.install the unit within the maximum elevationdifference above or below the outdoor unit and withina total tubing length (L) from the outdoor unit asdetailed in the installation instructions packed withthe outdoor unit.allow room for mounting the remote controller about3 ft. off the floor, in an area that is not in directsunlight nor in the flow of cool air from the indoorunit.NOTEAir delivery will be degraded if the distance from thefloor to the ceiling is greater than 10 ft.Ceiling TypeThe rear of the indoor unit can be installed flushagainst the wall.Min. 2 ft. Air intakeAirdischargeMin. 10 inchCeilingWallMax 25 cmNOTEMin. 10 inchSide viewFront viewCeilingWall Mounted TypeMin.6 inchMin.12 inchMin.6 inchLow Silhouette Ducted Type4-Way Cassette Type10 in.10 in.10 in.3 ft.3 ft.3 ft.3 ft.3 ft.Min.8 ft.Shows Low Silhouette Ducted Type onlyIndoor Unit1