Display POI iconsPOI icons for frequently used POIs (Gas stations,restaurants, etc.) can be displayed on the map. Detailedinformation can also be shown for the displayed POIicons. (Scale: 150 ft – 0.5 mile (50 m – 1 km*))* This is the scale when “km” is set as the distancesetting ( page 84).1 Select [Map view] on the currentposition screen. The Change map view screen is displayed.2 Select [Display POI icons]. The Display POI Icons screen is displayed.3 Select POI icons from the list andselect [OK]. Selected POI icons are displayed on the map. Up to 5 icons can be selected. Selected POIicons are displayed at the upper left. Selected POI icons can be cancelled by selectingthem again. Select [Delete] to cancel all selected POI icons. The icons for displayed POIs can be changed.Refer to page 84 for the change method.To select other POI icons, select [Other POIs] Go to step 44 Select a main category. Select [List all categories] to display thesub-categories within all main categories.5 Select POI icons displayed from thelist and select [OK]. Selected POI icons are displayed on the map. Up to 5 icons can be selected. To choose another category, select [More], thenrepeat from step 4. To see information on POI icons1 Put the cursor on POI icons, whichwill cause the cursor to fl ash. The POI name is displayed.2 Select [Info.]. POI information is displayed. Select [Enter ] to set it as the destination. If adestination has already been set, [Add to ] or[New ] is displayed. Refer to page 37 for details. [Mark]: Registers the point at the center of themap as a Contact (Address Book).Note: POI name display is automatically removed after it hasbeen displayed for approximately 6 seconds. If multiple POIs exist for the same building, the POI iconsmay overlap on the map. In that case, the POI names aredisplayed sequentially as their POI icons are selected. Departments and sections within the same POI may,in some cases, be displayed as individual POI icons.Search for a destination (continued)English5050