Panasonic Switch-M5eGLPWR+ Series Installation Manual

Also see for PN28058-ID: Operation manual

Contents

Panasonic Switch-M5eGLPWR+ Series Installation Manual Manual pdf 7 page image

Product OutlineSwitch-M5eGLPWR+ is an Ethernet Switching Hub with management function having 4ports of 10/100/1000BASE-T and two pairs of 10/100/1000BASE-T ports and SFPextension slot, one of which is selectable.Ports 1 to 4 support IEEE802.3at PoE power supply function.1.1 Features71 Has wire-speed Layer 2 switching function. Ports 1 to 4 are 10/100/1000BASE-T ports corresponding to auto negotiation.Also their speed and communication mode can be switched by configuration.Ports 5 and 6 can be used as a 10/100/1000BASE-T port corresponding to autonegotiation or an SFP extension slot exclusively. Ports 1 to 4 can supply power conforming with IEEE802.3at. Supplying power up to30 W per port, and up to 62 W in total is possible. All twisted pair ports support straight/cross cable auto sensing function. Simplyconnect devices with straight cables, whether it is a terminal or a network device.(This function does not work if the port communication configuration is set at Fixedor Link Aggregation. Ports 1 to 4 are set at MDI-X. (default)) Telnet allows remote configuration changes and verifications of the Switching Hub.Remotely configure the PoE settings for each port (Ports 1 to 4).Equipped with energy efficient Ethernet (EEE) conforming to IEEE802.3az (LPI).When there is no data transmission at link up, the energy-saving state automaticallystarts so that power consumption can be reduced on each port. Embedded power saving mode detects the connection status automatically andsaves power consumption to minimum. VLAN function allows free grouping of up to 256 VLANs. The IEEE802.1w Rapid Spanning Tree Protocol is supported, allowing to build asystem with redundancy. The IEEE802.1p compatible QoS function is supported. The IEEE802.1X compatible user authentication function (EAP-MD5/TLS/PEAP) issupported. Has an Internet Mansion function, which ensures security between each door. Due to the loop detection/shutoff function, a port where loop has occurred can beautomatically shut off to prevent loop failures. When a port is shut off andrecovered automatically, SNMP trap can be sent to notify the incident to theadministrator. Moreover, the port with a loop can be identified by loop notificationon the LEDs on the main unit and referring the history of loop on the setting screen. The PoE scheduler function enables scheduling of PoE power supply control.