Panasonic TH-37PWD7B Operating Instructions Manual

32Setup for Input SignalsComponent / RGB-in selectSelect the input signals to be connected by installing the Optional Terminal Board.(Refer to the Operating Instructions for the optional Terminal Board.)Select to match the signals from the source connected to the Component / RGB input terminals.Y, PB, P R signals “Component”R, G, B, HD, VD signals “RGB”12Press to display the Setup menu.Press to select the “Component / RGB-in select”.Press to select the desired input signal.Component RGBPress to exit from adjust mode.3D Y/C Filter – For NTSC AV imagesSelect “Signal” from the “Setup” menu during AV(S Video) input signal.(“Signal [AV]” menu is displayed.)Press to select the “3D Y/C Filter (NTSC)”Press to set On / Off.Press to exit from adjust mode.Note:When On, this setting only affects NTSC input signals.SET UPRRNotes:• Selection may not be possible, depending on which optional board is installed.• In case of PC input, only RGB can be selected.1/2PCOffStandby save OffPower management OffAuto power off OffOSD Language English (UK)Component / RGB-in selectRGBInput labelSignalPower saveSetup1/2PCOffStandby save OffPower management OffAuto power off OffOSD Language English (UK)Component / RGB-in selectRGBInput labelSignalPower saveSetupINPUTSURROUNDVOLN RPICTURE SOUND SET UPMULTIPIP SWAP SELECT MOVEZOOM312 Press ACTION ( ) button3D Y/C Filter (NTSC)Colour systemSignalOnAutoCinema realityPanasonic Auto (4 : 3)Off4 : 3[AV]P-NR Off