Panasonic TH-42PW5 Operating Instructions Manual

Also see for TH-42PW5: Service manual Service manual Service manual Operating instructions Operating instructions

12SERIAL Terminals connectionConnectionsNotes:(1) Use the RS-232C cable to connect the computer to the Plasma Display.(2) The computer shown is for example purposes only.(3) Additional equipment and cables shown are not supplied with this set.SERIALRS-232Cstraight cableD-sub 9pCOMPUTERLess than3" 15 /16(10 cm)Ferrite core(large size)(supplied)The SERIAL terminal is used when the Plasma Display is controlled by a computer.The SERIAL terminal conforms to the RS-232C interface specification, so that the Plasma Display can be controlledby a computer which is connected to this terminal.The computer will require software which allows the sending and receiving of control data which satisfies the conditionsgiven below. Use a computer application such as programming language software. Refer to the documentation for thecomputer application for details.Basic format for control dataThe transmission of control data from the computerstarts with a STX signal, followed by the command,the parameters, and lastly an ETX signal in that order.If there are no parameters, then the parameter signaldoes not need to be sent.Notes:(1) If multiple commands are transmitted, be sure towait for the response for the first command to comefrom this unit before sending the next command.(2) If an incorrect command is sent by mistake, thisunit will send an “ER401” command back to thecomputer.STXStart(02h)ETX:C2C1 C3 P2P1 P3 P4 P5Colon Parameter(s)(1 - 5 bytes)End(03h)3-charactercommand (3bytes)RS-232C Conversion cableD-sub 9-pin female2354 6781 • 9DetailsR X DT X DGNDNon useShortedNCPin layout for RS-232C98765321 4Communication parametersSignal levelSynchronization methodBaud rateParityCharacter lengthStop bitFlow controlRS-232C compliantAsynchronous9600 bpsNone8 bits1 bit-CommandCommandPONPOFAVLAMTIIS(WhenUsed RCATerminalBoard)DAMControl detailsPower ONPower OFFVolume 00 - 63Audio mute OFFAudio mute ONInput select (toggle)AV ModeComponent / RGB mode (processed as aY/PB /PR or RGB signals as set by this unit)PC ModeScreen mode select (toggle)4 : 3Zoom16 : 9JustPanasonic AutoParameterNoneNone**01NoneVIDYP1RG1NoneNORMZOOMFULLJUSTSELFWith the power off, this display responds to PON command only.OpenInstalling the ferrite core(Large size)If tuner is connected the SERIAL connection is disabled.