33Setup for Input SignalsColour system / Panasonic AutoSelect Signal from the “Setup” menu during AV(S Video) inputsignal mode.(“Signal [AV]” menu is displayed.)Press to select the “Colour System” or “PanasonicAuto”.Press to select each functions.3D Y/C Filter (NTSC)Colour system3:2 PulldownOnAutoOffPanasonic Auto (4:3) 4 : 3Signal [ AV ]If the picture image becomes unstable:With the system set on Auto, under conditions oflow level or noisy input signals the image may inrare cases become unstable. Should this occur, setthe system to match the format of the input signal.MULTI DISPLAY SetupSet up TIMERSetupSignalScreensaverComponent/RGB-in selectRGBOSD Language English (UK)Press (ACTION) buttonModeColour systemPanasonic Auto(4:3)FunctionSet the colour system to match the input signal. If set to “Auto”, the colour system is determinedautomatically.Set to “4 : 3” to view 4:3 images in an unchanged format when Panasonic Auto isselected. If you would like to view 4:3 images in “Just” format, set to “Just”.MULTI DISPLAY SetupSet up TIMERSetupSignalScreensaverComponent/RGB-in selectRGBOSD Language English (UK)3D Y/C Filter (NTSC)Colour system3:2 PulldownOnAutoOffPanasonic Auto (4:3) 4 : 3Signal [ AV ]Signal [ Component ]3:2 Pulldown Off3:2 PulldownSelect “Signal” from the “Setup” menu during AV(S Video) or Componentinput signal mode.(“Signal [AV]” menu is displayed.)Press to select 3:2 Pulldown.Press to set On/Off.Press to exit from adjust mode.RPress (ACTION) buttonNote:When On, this setting only affects the following signal input.• NTSC signal input during “AV(S Video)” input signal mode.• 525i(480i) signal input during “Component” input signal mode.When on, the display attempts to reproduce a more natural interpretation of sources such as movie pictures, which arerecorded at 24 frames per second.If the picture is not stable, turn the setting to off.Auto PAL SECAM M.NTSC NTSC