6.14. Remove the SS-Board1. Disconnect the connectors (SS11, SS12 SS23, SS24,SS33 and SS35).2. Remove a short-jumper connector SS34 and re-use for newSS-Board.3. Disconnect the flexible cables (SS54 and SS55).4. Remove the screws (×7 ) and remove the SS-Board.6.15. Remove the stand brackets1. Remove the plasma panel section from the servicing standand lay on a flat surface such as a table (covered) with theplasma panel surface facing downward.2. Remove the stand brackets (left, right) fastening screws (×5each) and remove the stand brackets (left, right).6.16. Remove the C1-Board1. Remove the tuner unit. (See section 6.4.)2. Remove the stand bracket (R). (See section 6.15.)3. Remove the flexible cables holder fastening screws (×10).4. Disconnect the flexible cables (CB1, CB2, CB3, CB4 andCB5).5. Disconnect the flexible cables (C10 and C11).6. Remove the screws (×5 ) and remove the C1-Board.6.17. Remove the C2-Board1. Remove the tuner unit. (See section 6.4.)2. Remove the flexible cables holder fastening screws (×6).3. Disconnect the flexible cables (CB6, CB7 and CB8).4. Disconnect the flexible cables (C20, C21 and C22).5. Remove the screws (×4 ) and remove the C2-Board.13TH-50PX77U / TH-50PE77U
