Panasonic TH-50PV600AZ Service Manual

Also see for TH-50PV600AZ: Operating instructions Service manual

Contents

hotel mode

I TH-50PV600AZ / TH-50PV600H / TH-50PV600M / TH-50PV600MTI3 Prevention of Electro Static Discharge (ESD) toElectrostatically Sensitive (ES) DevicesSome semiconductor (solid state) devices can be damaged easily by static electricity. Such components commonly are calledElectrostatically Sensitive (ES) Devices. Examples of typical ES devices are integrated circuits and some field-effect transistors andsemiconductor "chip" components. The following techniques should be used to help reduce the incidence of com ponent damagecaused by electro static discharge (ESD).1. Im m ediately before handling any semiconductor component or semiconductor-equipped assembly, drain off any ESD on yourbody by touching a known earth ground. Alternatively, obtain and wear a comm ercially available discharging ESD wrist strap,which should be removed for potential shock reasons prior to applying power to the unit under test.2. After removing an electrical assembly equipped with ES devices, place the assembly on a conductive surface such as alminumfoil, to prevent electrostatic charge buildup or exposure of the assembly.3. Use only a grounded-tip soldering iron to solder or unsolder ES devices.4. Use only an anti-static solder removal device. Some solder removal devices not classified as "anti-static (ESD protected)" cangenerate electrical charge sufficient to damage ES devices.5. Do not use freon-propelled chemicals. These can generate electrical charges sufficient to damage ES devices.6. Do not remove a replacement ES device from its protective package until immediately before you are ready to install it. (Mostreplacement ES devices are packaged with leads electrically shorted together by conductive foam , alminum foil or comparableconductive material).7. Im m ediately before removing the protective material from the leads of a replacement ES device, touch the protective materialto the chassis or circuit assembly into which the device will be installed.CautionBe sure no power is applied to the chassis or circuit, and observe all other safety precautions.8. Minimize bodily motions when handling unpackaged replacement ES devices. (Otherwise hamless motion such as the brushingtogether of your clothes fabric or the lifting of your foot from a carpeted floor can generate static electricity (ESD) sufficient todamage an ES device).IMPORTANT SAFETY NOTICEThere are special components used in this equipment which are imporant for safety.These parts are marked by Д in the schematic diagrams, Exploded Views and replacement parts list. It isessential that these critical parts should be replaced with manufacturer's specified parts to prevent shock, fire, orother hazards. Do not modify the original design without permission of manufacturer.7