44 45AdvancedOperating Peripheral EquipmentUsing TimerMenuPictureAudioLockSetupMemory cardTimerTVG/Photo-TimerSleepTimer 1Timer 2Timer 3Timer 4Timer 560SleepSleep310 - 1EVR FRI10:00 AM11:00 AMOnTimer 1CHDayOn timeOff timeSet SUN/MON/TUE/WED/THU/FRI/SAT/MON-FRI/SAT-SUN/DAILY/EVR SUN/EVR MON/EVR TUE/EVR WED/EVR THU/EVR FRI/ EVR SATUsing TimerSelect “Timer”Select the timer to set32Set the timer4selectDisplay menu1selectnextnextselectTurns Off automaticallySleepTurns On/Off automatically(5 timers can be set.)Timer 1Timer 5~selectsetSelect the channelCHSelect the dayDayThe time to turn OnOn timeThe time to turn OffOff timeTimer setting (On/Off)SetŶTo set “Sleep” (Off Timer)Press to set unit to shut itself off after a preselected amount of time.ŶPress to exitŶPress to returnto the previousscreenNote• The TV automaticallyturns Off after 90minutes when turnedOn by the Timer.This operation will becancelled if the Offtime is selected or if akey is pressed.The TV can automatically turn On/Off at the designated date and time.• The Clock must be set before On time/Off time settings. (p. 13)• 0/30/60/90 (minutes)ŶTo set “Timer 1-5” (On/Off Timer)Select the item and setOperating Peripheral EquipmentYou can operate other manufacturers’ components using this TV’s remote control.412 Press both buttons simultaneouslyfor more than 3 seconds.• Release the buttons when the equipment selectionbuttons start flashing.+35Caution• Registration will fail if the wrong code is input or it takes more than 30 seconds to register.Select the equipmentwith the equipment selection button• The selected button remains lit (other buttons are notlit).Connect the external devices to the TV andturn Off the external equipmentInput the equipment’s 4-digit remotecontrol code (p. 49-50)Confirm the equipment with theremote control• The external equipment turns On.ŶIf the equipment does not operate withremote control• When your equipment has a single codeInput the remote control code again• When your equipment has multiple codesChange the code with above and test again(p. 49-50)After step above, change the code andtest storeOperate the equipment with theremote control (p. 48)• Repeat until the code is found• It may take many attempts before the correctcode is foundWhen the correct code is foundchangeTo find a code not listed in the code listThis procedure searches all codes and is called the “sequence method.”