46 47AdvancedRecommended AV ConnectionsRF OUTRF IN • Turn Off the TV speakers.(p. 32 “Speakers”)ŶTo watch digital video imageS-Video signals have priority ŶTo listen to the TV throughspeakersAmplifierDVD Player or Set Top Box(HDMI compatible machines only)orŶTo record TVshowsDVD Recorder /VCRRecommended AV ConnectionsThese diagrams show our recommendations for how to connect the TV unit to your various equipment.For other connections, consult the instructions of each equipment, and the specifications (p. 61).For additional assistance, please visit our website at : www.panasonic.comwww.panasonic.caCamcorderS-VideoCamcorderVCR/S-VideoVCRDVD PlayerŶTo watch camcorderimagesINPUT3ŶTo watch DVDsDVD PlayerSet Top BoxCaution• For Antenna connection via VCR, please refer to the Operating Instructions for your VCR.• If you use both IR Blaster and “HDAVI Control” (P. 34) for the same Panasonic DIGA (with VCR type), please set“Power off link” (under “Other adjust” of “Setup” menu ) to “No” (P. 34), to avoid failure for your recording.Cable TVHDMIcableHDMI-DVIconversioncableAudio cableorŶRecommended HDMI Connections (p. 36-37)• For receiving digital broadcasting of cable TV,connect Cable TV directly to “ANTENNA CableIn” terminal.orAC Cord(Connect after all the otherconnections.)Back of the unit• Digital audio amplifier• Theater systemIR Blaster(Supplied)(VCR Only)VCRG-LINK•CableCARD™Insert a card to watch cable channels serving digitalhigh-definition video.Consult the cable company for information.•IR Blaster (p. 56)You can operate the VCR from the TV remotecontrol or reserve recording with TV Guide.Install the light emitting area of the IR Blaster nearthe signal-receiving area for the remote control onthe VCR.Signal-emitting areaof remote control Signal-receiving area ofremote controlTop shelf of TV standVCRMount withtwo-sided tapeSignal-emittingareaAudio cableRGB PC cableŶTo watchcable TVŶPCComputerCableCARD™Conversion adapter (if necessary)F-TypeAntennaAdapterNote• To make schedule recording using TV Guide with IRblaster, you have to select in your VCR Line-1 (L-1)and set your VCR in OFF condition. (Refer to theOperating Instruction manual of VCR)Note• The picture and audio input signalsconnected to a terminal specified in “Prog-out stop” (p. 32) cannot be output from“OUTPUT” terminals. However, audiooutput can be obtained from the opticalDigital Audio Out terminal.• To prevent howling and image oscillation, setthe “Prog-out-stop” setting when connectingVCR with loop-connection. (p. 32)• When a device (STB, DVD, etc.) isconnected to the HDMI or COMPONENTterminals, only audio signals will beoutput. No video signals will be output.oror