13Quick start GuideNotes:If the recording device has not accepted download data from the TV, you may need to select the Download option fromthe device’s menu system.Refer to the recording device’s operating instruction book.If Q-Link is not operating correctly, check the following:• The Scart cable is connected to the TV’s correct Scart socket.• The Scart cable is connected to the VCR’s compatible (Q-Link, NEXTVIEWLINK or similar technology) Scart socket.• The Scart cable is a “fully wired” type.For further information on Q-Link and connecting equipment, see pages 18 and 45.• The sorted programme order depends upon the TV signal, the broadcasting system, and reception conditions.If the order is not to your preference it can be rearranged. Refer to the Programme edit menu - see page 17 for details.• If you have a digital satellite receiver, you can start Auto setup with the receiver set to any channel. You will then have tomanually name the ‘SAT’ position after Auto setup is complete. Refer to the Programme edit - see page 38 for details.Prog. Position All channels No CH5 No CH5/S4C No CH4/CH5 No S4C No CH4/S4C No CH4/S4C/CH51 BBC1 BBC1 BBC1 BBC1 BBC1 BBC1 BBC12 BBC2 BBC2 BBC2 BBC2 BBC2 BBC2 BBC23 ITV ITV ITV ITV ITV ITV ITV4 CH4 CH4 CH4 S4C CH4 CH5 SAT5 S4C S4C SAT SAT CH5 SAT ∗6 CH5 SAT ∗ ∗ SAT ∗7 SAT ∗ ∗ ∗ ∗ ∗ ∗Note:∗ The next available channel will appear, If no other stations are available then the Programme position will remain nunsed.TV/AV : To exit21 68AUTO SETUP IN PROGRESSSEARCHING:PLEASE WAITDOWNLOAD IN PROGRESSPLEASE WAITProgramme : 11Remote control unavailableFirst, ensure that the recording device is in Standby mode,if it has Q-Link function and Satellite receiver is switchedON.Plug in TV and switch on.Programmes will appear immediately if your dealer has programmed the TV foryou.If the TV has not been programmed for you then Auto setup will begin,yourstations will be located,sorted into order and stored ready for use.TV to VCR /DVD recorder downloadIf a Q-Link, NEXTVIEWLINK or compatible recording device has been connectedto the correct Scart socket before starting Step 1 , programme information willbe downloaded to the device via Q-Link.Downloaded tuning data will match the television’s.Not all recording devices support this download of programme information, somemay require to be started manually. Refer to the device’s operating instruction book.lf a recording device other than those described above has been connected,then there will be no download operation.Auto setup