Panasonic TU-DST50 Operating Instructions Manual

Also see for TU-DST50 Operating: Operating instructions

Panasonic TU-DST50 Operating Instructions Manual Manual pdf 44 page image

PROGRAMMING THE REMOTE CONTROLProgramming the Remote ControlThe Universal Remote Control can be programmed to operate many manufacturers'components using the component function buttons for VCR, DVD, AUX, RCVR, DTV,TV, CBL, or DBS. Follow the procedures for programming your Remote Control withand without codes for the component. Determine the manufacturer of the componentand look in the table for the code.Note: Be careful to press ACTION in the middle of the button. If you do not press in themiddle of the button, the arrow buttons may be activated. This will interrupt yourprogramming.Programming With Code• Confirm that the external component is plugged in and is turned on.• Turn the component off.• Press the ACTION and POWER button, together, for at least 5 seconds. Allmode buttons will flash, then let go of the buttons.• Press appropriate component'button (VCR, CBL, etc.) on the RemoteControl. The pressed button will illuminate steadily. All other buttons will goout.• Enter the 3-digit component code using the Remote Control numeric keypad(0 ~ 9 buttons). If a proper code was entered, the mode button will blink twiceand go out.• Press the Remote Control POWER button to test the component. If theprocedure was successful, the component will turn on._ _ _;_unsuccessful CodeIf the component does not operate with the Remote Control,repeat the procedure using another code. (Somebrands have multiple codes.)If an incorrect code is entered, or if the procedure takes longerthan 30 seconds, the programming will fail.Programming Without CodeThis procedure searches all codes and is called the "sequence method".• Confirm that the external component is plugged in and is turned on.• Turn the component off.• Press the ACTION and POWER button, together, for at least 5 seconds. Allmode buttons will flash, then let go of the button.• Press appropriate component button on the Remote Control. The pressedbutton will illuminate. All other buttons will go out.• Press the D, button to move forward to the next code. Press the _1 button tomove backward.• Press the Remote Control POWER button to test the component. If theprocedure was successful, the component will turn on.Note: Repeat the preceding two steps until the component code is found. It may take many attemptsbefore the correct code is found.• After the code is found, press the ACTION button to store the code.[]