Panasonic TX-32DK2 Operating Instructions Manual

84. Q--Link connection of TV, VCR and Satellite Receiver using Scart and RF cablesFor Q--Link to function correctly the TV, VCR and Satellite Receiver must be connected as shown in the diagram below.Scart Connections’Fully wired’ Scart cables should be used for all of the Scart connections.D The AV2 Scart of the VCR must be connected to the VCR socket of the Satellite Receiver.D The TV Scart socket of the Satellite Receiver must be connected to the AV1 Scart socket of the TV.Note :If using a “Q--Link” VCR then the AV1 Scart of the VCR must be connected to the AV2 socket of the TV. If your VCR is not a “Q--Link”VCR, please consult your VCR operating instruction book.RF ConnectionsD Connect an RF cable to the Aerial In socket of the Satellite Receiver.D Connect an RF cable from the RF Out socket of the Satellite Receiver to the RF In socket of the VCR.D Connect an RF cable from the RF Out socket of the VCR to the TV Aerial In socket ( ).MainsSocketTVSATELLITERECEIVERVCR ScartsocketTV ScartsocketAerialInputsocketAerialOutputsocketAV2Scart socketVCRMainsSocketMainsSocket AerialInputsocketAerialOutputsocketAerialInputsocketAV1 ScartsocketAV2 ScartsocketAV1Scart socketNotes :Additional equipment and cables are not supplied.Further details of Audio/ Video connections can be found on pages 40 and 41.Further information for VCR and Satellite Receiver installation with this TV can be found on page 36.QUICK START GUIDE