Panasonic TX-32LXD55F Operating Instructions Manual

22Common Interface Module (DVB mode)Press the MENU button.Move to choose Setup menu.Access Setup menu.Move to choose DVB Setup Menu.Access DVB Setup Menu.Move to choose System Setup.Access System Setup.Move to choose Common Interface Module.Access Common Interface Module.Access the module.The Common Interface Module menu provides access to software contained on Common Interface (CI) Modules.These can be inserted in the “CI” slot located at the rear of the TV.IMPORTANT NOTES:• Switch off the TV using the front panel switch before inserting or removing a module.• If you are installing a TV software update, please follow the dedicated instructions supplied with themodule.• Insert / remove a module straightly to the CI slot.Insert the CI module:Some Common Interface Modules may be a two piece design consistingof a card reader together with the viewing card. When using this designof card, first insert the card reader firmly into the CI slot on the TV.Secondly, insert the viewing card into the reader.If no module is inserted the message “No module inserted” will bedisplayed.(If you have inserted a module, check that it is fully inserted.)The features that now appear on screen are dependent on the contentsof the selected Common Interface Module.Refer to the instructions supplied with the card or contact the vendor.In all cases, it is possible to navigate the pages using buttons on theremote control, but because the commands available must apply to allmanufacturers of DVB equipment, some on screen commands may notcorrespond exactly to the remote control buttons.For example:For the on screen command ‘select’ or ‘go’, use the OK button.If you see the symbols, use the cursor buttons.If you see a line of key words displayed in red, green, yellow and blue,use the coloured buttons to operate the functions.The EXIT button should always allow you to exit the CI software.Switch on the TV.In DVB modeCommom InterfaceAuto3 secondsCommon Interface ModuleTime ZoneDVB System Setup AccessDisplay TimeoutPreferred Language SettingSlot 1: No module insertedCommon Interface AccessMENU1 2 34 5 67 8 90IDTVNOKCMODEEXITOK