Panasonic TX-PR37X10 Service Manual

1. Remove the Cabinet assy. (See section 7.16.)2. Remove the S-Board. (See section 7.17.)3. Remove the screws (x5 ^ ) .4. Remove the Glass holder bottom rear.5. Remove the screws (x4 H>)-6. Remove the Glass holder side (L, R).7. Remove the screws (x7 O ) -8. Remove the Glass holder top rear.9. Remove the Front glass.10. Remove the Glass holder bottom front and Glass holdertop front.7.18. Remove the Front glassCabinet assy Glass holder top frontGlass holder bottom front7.19. Remove the K-Board1. Remove the Front glass. (see section 7.18)2. Remove the claw (x1 O ) -3. Disconnect the connector (K1) and remove the K-Boardfrom LED Panel.K1LED Panel K-BoardCaution:A new plasma panel itself without Hanger metals isfragile.To avoid the dam age to new plasma panel, carry a newplasma panel taking hold o f the Hanger metals afterassembling the Hanger metals and the Stand brackets.1. Place a carton box packed a new plasma panel on the flatsurface of the w ork bench.2. Open a box and without taking a new plasma panel;Attach the C1-Board and the C2-Board, connect the flexible cables from the plasma panel to the C1-Board and theC2-Board, and fit the flexible cable holders.3. Attach the Hanger metals and the Stand brackets to thenew plasma panel.4. Place the plasma panel on the servicing stand taking holdof the Hanger metals.5. Attach the cabinet assy and each PC.Board and so on, tothe new plasma panel.*When fitting the cabinet assy, be careful not to allow anydebris, dust or handling residue to remain between thefront glass and plasma panel.7.20. Replace the plasma panel22