- 62 -3. Select LNB Configuration with / and press OK to access● Select Dual Tuner Mode with / , set to On with / to use dualtuner function.4. Select LNB / Satellite with / and set with /● Select IN 1 / IN 2 in Signal Input with / to set for each tuner.1) Set LNB first– If you set to One LNB, LNB is not selectable.– If you set to MiniDiSEqC or Single Cable, select from LNB AA andAB.– If you set to DiSEqC 1.0, select from LNB AA, AB, BA and BB.2) Set Satellite for the selected LNB– Select No Satellite if you do not know the connected satellite(available satellite will be searched in Auto Setup).– Select User defined to set Test Transponder Frequency manually.– If you set to Single Cable, additional settings are required. Set UserBand, User Band Frequency and PIN (depending on the SingleCable router you use). For details, read the manual of the SingleCable router.Watching Tuning and editing channels Selectable satellites5. Press BACK/RETURN to store6. Select Auto Setup with / and press OK to access7. Select Satellite / Search Mode / Scan Mode with / and press OK toaccess8. Set with / and press OK to store● Scan ModeFull:Scans the whole frequency range.Quick:Scans the suitable frequency for the selected satellite.● After settings, select Start scan with / and press OK to search.9. The confirmation screen is displayed and press OK to start Auto Setup(Settings are made automatically)● When the operation is completed, the channel at the lowest position willbe displayed.
