Panasonic TY-WK42PR2W Fitting Instructions Manual

Contents

Panasonic TY-WK42PR2W Fitting Instructions Manual Manual pdf 4 page image

English4Fitting procedure2. Fit wall-hanging bracket to wall• Fit so that the arrow marks on the wall-hanging bracket point upward.• If the wall consists of a material such as concrete and bolts or nuts mustbe embedded beforehand, determine the hole positions by aligning usingthe actual wall-hanging bracket, or calculate hole positions based on thedimension drawing, and then embed "M6" bolts or nuts. Whenembedding bolts, locate so that the bolts protrude from the wall by 10 to15 mm.(1) Fasten the screw at the top center hole first.(2) Using a level, correct any bracket inclination, and then fastenscrews at the remaining 5 locations.• There are 14 holes in the wall-hangingbracket.If the wall material is wood, and adequateattachment strength cannot be ensuredby fastening at the 6 points at right, useas many spare holes as necessary.However, exercise care because somewall materials may crack if screws arelocated too close together.* For detailed dimensions for attaching theplasma TV, refer to the separate ExternalDimension Drawing (page38 -39).Note• Use commercially available M6 screws suited to the wall surface material (wood,steel frame, concrete etc.) for fitting the bracket to the wall.Note490450 2020450450 1515 930Unit: mm * Be sure to fit screws and tighten securely .3. Angle adjustment of wall-hanging bracketThe angle of the wall-hanging bracket can be adjusted from "no incline"to "20° incline" in 5 settings at intervals of 5°(The TH-50PV30E, TH-50PV30B has 4 settings, ranging up to "15°incline.")The bracket is set to 5° before shipment from the factory.To change the angle, move the attachment position of the strap.* The strap is not needed for the "no incline" setting.Wall surfaceWall surfaceStrapWall surfaceAngle adjustment hole positions5° incline10° incline15° incline20° inclineNo inclineAt 5° incline At 15° incline No inclineWall attachmentholes (at 6 points)1. Confirm the strength of the proposed fitting locationThe weight of the wall-hanging bracket is approximately 10 kg. The plasma TV unit attachedto the wall-hanging bracket weighs approximately 34.5 to 56 kg.Check the wall strength at the 6 attachment locations by referring to the dimension drawingof the wall-hanging bracket (given at right), and provide adequate reinforcement if strengthis not sufficient.