Panasonic Toughbook CF-18DHAZXKM Operating Instructions Manual

Also see for Toughbook CF-18 Series: Precautions for Installing Precautions for Installing Operating instructions Supplementary instructions Supplementary instructions

28 TroublesahootingList of Error CodesWhen turning on the computer, if one of the following error codes or messages is displayed, follow the instructions shown below.If the problem persists, or if the error code or message displayed is not shown here, contact Panasonic Technical Support.Error Code/Message0211: Keyboard error0251: System CMOS checksumbad - Default configurationused0271: Check date and time set-tings0280: Previous boot incomplete- Default configuration used0613: Serial Port*1 configura-tion changed0614: Serial Port*1 config. error- device disabled*1 The port name, such as A or B, isdisplayed, indicating the conflict-ing ports.Press to resume, toSetupOperating System not foundActionIf an external keyboard or mouse is connected, disconnect these devices.An error has occurred in the memory that stores the Setup Utility settings. This error occurswhen the memory content is changed through some inadvertent operation by a program orother function.Run the Setup Utility and load the default values, then change the settings to the appro-priate values as needed.If the problem persists, the internal clock battery may need to be replaced. Contact Pana-sonic Technical Support.The data and time setting are incorrect.Run the Setup Utility and set the date and time correctly.If the problem persists, the internal clock battery may need to be replaced. Contact Pana-sonic Technical Support.Startup has failed repeatedly, so the Setup Utility settings have been returned to their defaultvalues, and the computer has been restarted.Run the Setup Utility and load the default values, then change the settings to the appropri-ate values as needed.I/O address and IRQ settings are in conflict.Run the Setup Utility and change the settings in [Advanced] menu so there is no portconflicts.Write down the error details and press F2 to run the Setup Utility. Confirm thesettings, and change the settings to the appropriate values as needed.The OS is not properly installed on the floppy disk or the hard disk that you are trying toboot from.If the computer cannot be booted from the floppy disk, check the floppy disk drive toensure that the disk is in fact bootable, and change it to another if not.If the computer cannot be booted from the hard disk, confirm whether the hard disk isproperly recognized in [Information] menu of the Setup Utility.If the hard disk is recognized, perform the reinstallation procedure. If not, contact Pana-sonic Technical Support.If a device is connected to the USB port, disconnect the device, or run the Setup Utilityand set [Legacy USB Support] in [Advanced] menu to [Disable].To run the Setup Utility1 Restart the computer.2 Press F2 while [Panasonic] boot screen is displayed soon after the computer begins the startup procedure.