Panasonic Toughbook CF-48 Series Reference Manual

Also see for Toughbook CF-48 Series: Reference manual Operating instructions Service manual Reference manual Operating instructions

52List of Error CodesThe following is a list of the messages that BIOS can display. Most of them occur during POST. Some of them displayinformation about a hardware device, e.g., the amount of memory installed. Others may indicate a problem with adevice, such as the way it has been configured. Following the list are explanations of the messages and remedies forreported problems.If your system displays one of except the messages marked below with an asterisk (*), write down the message andcontact Panasonic Technical Support. If your system fails after you make changes in the Setup menus, reset thecomputer, enter Setup and install Setup defaults or correct the error.0200 Failure Fixed DiskFixed disk in not working or not configured properly. Check to see if fixed disk is attached properly. Run Setup. Find out if the fixed-disk type iscorrectly identified.0210 Stuck keyStuck key on keyboard.0211 Keyboard errorKeyboard not working.0212 Keyboard Controller FailedKeyboard controller failed test. May require replacing keyboard controller.0213 Keyboard locked - Unlock key switchUnlock the system to proceed.0230 System RAM Failed at offset : nnnnSystem RAM failed at offset nnnn of in the 64k block at which the error was detected.0231 Shadow RAM Failed at offset : nnnnShadow RAM failed at offset nnnn of the 64k block at which the error was detected.0232 Extended RAM Failed at offset : nnnnExtended memory not working or not configured properly at offset nnnn.0250 System battery is dead - Replace and run SETUPThe CMOS clock battery indicator shows the battery is dead. Replace the battery and run Setup to reconfigure the system.*0251 System CMOS checksum bad - Default configuration usedSystem CMOS has been corrupted or modified incorrectly, perhaps by an application program that changes data stored in CMOS. The BIOSinstalled Default SETUP Values. If you do not want these values, enter Setup and enter your own values. If the error persists, check the systembattery or contact Panasonic Technical Support.0260 System timer errorThe timer test failed. Requires repair of system board.0270 Real time clock errorReal-time clock fails BIOS test. May require board repair.*0280 Previous boot incomplete - Default configuration usedPrevious POST did not complete successfully. POST loads default values and offers to run Setup. If the failure was caused by incorrect valuesand they are not corrected, the next boot will likely fail. On systems with control of wait states, improper Setup settings can also terminatePOST and cause this error on the next boot. Run Setup and verify that the wait-state configuration is correct. This error is cleared the next timethe system is booted.0281 Memory Size found by POST differed from EISA CMOSMemory size found by POST differed from EISA CMOS.02B0 Diskette drive A error02B1 Diskette drive B errorDrive A: or B: is present but fails the BIOS POST diskette tests. Check to see that the drive is defined with the proper diskette type in Setupand that the diskette drive is attached correctly.02B2 Incorrect Drive A type - run SETUPType of floppy drive A: not correctly identified in Setup.02B3 Incorrect Drive B type - run SETUPType of floppy drive B: not correctly identified in Setup.02D0 System cache error - Cache disabledContact Panasonic Technical Support.02F0: CPU ID:CPU socket number for Multi-Processor error.02F4: EISA CMOS not writableServerBIOS2 test error: Cannot write to EISA CMOS.