Panasonic Toughbook CF-71 Series Operating Instructions Manual

Also see for CF-71 Series: Operating instructions Reference manual Reference manual Reference manual Reference manual

Contents

9 Getting Started5 Input the Product Number written on the “Certificate of Authenticity” located inthe Windows® 95 book that comes with this computer then press [Next].Press [Finish].6MP4 After reading the agreement, select [I accept the agreement] or [I don't accept theagreement], then press [Next].If [I accept the agreement] is selected, the [Certificate of Authenticity] willappear. If [I don't accept the agreement] is selected, the Windows setupwill be aborted.NOTESetup Windows 955 Turn your computer on4Slide the power switch toward the rear of the computer and hold it for approximatelyone second until the power indicator turns on before releasing it.3 Enter your name and your company’s name, then press [Next].(It is possible to omit the company name item.)The License Agreement will be displayed.Select settings for your region, then press [Next].Select your keyboard layout, then press [Next].(for U.S.A.: United States 101)21Moving the cursor ( ) or clicking buttons can be performed with the touchpad. ( page 14)NOTEPower SwitchRead the LIMITED USE LICENSE AGREEMENT ( page 26)Before removing the seal covering the power switch, please read the LIMITED USE LI-CENSE AGREEMENT.CAUTIONAfter confirming that the power indicator has turned on, do not touch the powerswitch until Windows setup has started.Once the computer is powered off, you must wait at least ten seconds beforepowering it on again.Power Indicator6The power saving function is factory set, so if there is no input from a key, the touchpad, or the external mouse for two minutes, the power to the LCD is cut (ECOmode).The LCD will resume operation when the touch pad or the external mouse is usedor a key is pressed.The computer may enter the ECO mode while Windows is setting up or even whenan application software is being installed. In this case, because it is conceivablethat a selection dialog box will be shown, for resuming from the ECO mode, do notpress Enter which may trigger a selection, but instead, press a key unrelated tothe direct triggering of a selection, like .NOTEShift