Panasonic Toughbook CF-71 Series Reference Manual

Also see for CF-71 Series: Operating instructions Operating instructions Reference manual Reference manual Reference manual

47Your peripheral does notwork (An error occurswhile installing the driver)Unable to printThe cursor does notmove from mouse opera-tionsThe device connected tothe serial port does notworkE x t e r n a l m o u s e o rtrackball connected tothe external keyboard/mouse port does notworkA PC Card does not workYou do not know theavailable RAM moduleThe RAM module has notbeen recognizedThe address map forIRQ, I/O port address,etc. is unclearA USB device does notworkYou need to use drivers conforming to Windows 95 Version 4.00.950C (OSR-2.5).Some earlier drivers will no longer work.For more information, please ask the manufacturer of the driver in question.Check the computer-printer connection.Make sure the printer is on.Make sure the printer is in the online state.Make sure paper is in the printer tray and there is no paper jam.Has the Setup Utility been used to set [Parallel Port (Address)] to [Automatic (PnP)],[378] or [3BC]?The Coffee break Password may be set; check if is displayed. If this is thecase, input the Coffee break Password.Check your mouse connection, then reboot the computer from the keyboard.From the keyboard, you may choose to press down on , then select [ShutDown].Check the connection.Confirm that the device driver for the serial port works. Please refer to the refer-ence manual of the device.Confirm that two mouse devices are not connected, one through the external key-board/mouse port and the other through the serial port.Try setting [Touch Pad] to disable in the Setup Utility.Has the Setup Utility been used to set [Serial Port] to [Automatic (PnP)] or [3F8]?Try setting [Touch Pad] to disable in the Setup Utility.In some circumstances, if a PS/2 external mouse with a serial interface conver-sion function is connected to the port, it may not operate normally. Try connectingit to the serial port.If a switch is made to the Hand Written mode in Panasonic Hand Writing, anyexternal mouse or trackball connecting to the external keyboard/mouse port willnot operate. Reconnect the device after quitting the Hand Written mode. If thedevice still does not work, try restarting the computer.Make sure the card is properly inserted.Confirm that the card conforms to the PC Card Standard.Note that after a driver is installed, the computer must be rebooted.Check that the proper port settings have been made.Read the PC Card’s manual. Or, you may need to call the manufacturer of the PCCard.If the ZV card does not operate properly, install PhoenixCard Manager TM for Win-dows® 95. ( page 24)page 25Make sure the RAM module has been properly inserted.Use the RAM module that support the recommended specifications.Check the address map by going to [View Resources] in [Start] - [Settings] - [ControlPanel] - [System] - [Device Manager] - [Computer] - [Properties].Make sure a driver is installed.Contact the manufacturer of the product.Dealing With ProblemsConnecting Peripherals

/ 48

Related manuals for Panasonic CF-71 Series