Panasonic Toughbook CF-W2DWADZBM Operating Instructions Manual

Also see for CF-W2 Series: Operating instructions User guide Operating instructions Operating instructions Operating instructions

29 Getting Started*1 This is displayed only when an SD memory card has been registered. (Î “Chapter 4: SDMemory Card Security Function” in onscreen Reference Manual)NOTEz When the Setup Utility is started up with the User Password:• [Clear registered SD card], [Set Supervisor Password] and [Hard Disk Lock]will not be displayed• [Password on boot], [SD Startup], [SD Setting Method], [Setup Utility Prompt],[Boot First Menu] and [User Password Protection] will be displayed, but cannotbe set• The User Password can be changed only when [User Password Protection]has been set to [No Protection]. The User Password cannot be deletedParameters(An underline indicates the factory default settings)*2 [SD Startup] and [SD Setting Method] cannot be set if [Password on boot] is set to [Disable].Security MenuPassword on boot: [Enable]SD Startup: *1 [Enable]SD Setting Method:*1 [Leave Set]XClear registered SD card: *1 [Enter]XSet Supervisor Password: [Enter]Setup Utility Prompt: [Enable]Boot First Menu: [Enable]Hard Disk Lock: [Disable]User Password Protection: [No Protection]XSet User Password: [Enter]Password on bootz Select whether you will need to input ([Enable]) or not ([Dis-able]) the Supervisor Password or the User Password onbootingDisableEnableSD Startup *2z Select whether to use an SD memory card instead of enter-ing the password on booting ([Enable]) or not ([Disable])DisableEnableSD Setting Method*2z Select whether to set an SD memory card to [Leave Set] or[Set and Eject] when an SD memory card is used instead ofentering the passwordz This can be set only if [SD Startup] has been set to [Enable]Leave SetSet and EjectClear registered SD cardz Clear the registration from all registered SD memory cardsnot to be used instead of entering the password on bootingTo the sub-menuSet Supervisor Passwordz Set a Supervisor Password if you wish to prevent any unau-thorized changes to the Setup Utility settings, also if yourequire a password on boot, set [Password on boot] to[Enable] after you set Supervisor PasswordTo the sub-menu