Panasonic U-72MF1U9 Service Manual

Also see for U-72MF1U9: Installation instructions Operating instructions Operating instructions Technical data

2 - 10Remote Control Functions2. Wireless Remote Controller1234567When mounting thewireless remote controlunit on a wall for use• Before mounting the wireless remote control unit on the wall, place the unit at the mountingposition, press the ON/OFF operation button and check that the signals are receivedproperly.• To remove the wireless remote control unit, disengage it by pulling it toward you.Operating tips • Do not operate the wireless remote control unit too far away from the signal receiver.Doing so may cause operational errors.Make absolutely sure that the wireless remote control unit and signal receiver are both inthe same room.• When operating the wireless remote control unit, point it directly at the signal receiver.A beep is heard when a signal is received properly.• Avoid places where the wireless remote control unit will be obscured by curtains, etc.Remove it before operation.Secure the installation fitting of the wirelessremote control unit using the screws.Press.12Place here.Installation fitting of wireless remote control unitProcedure for installing thewireless remote control unitWhen a multiple number of indoor units that can be operated by the wireless remote control unithave been installed in the same room with a multi-unit or single-unit installation, this button enablesaddresses to be set in order to prevent the sending of signals to the wrong indoor unit. Each of up tosix indoor units can be controlled separately using its own wireless remote control unit by matchingthe number of the address switch on the operation area of the indoor unit and the number used forthe address of its wireless remote control unit. (The indoor units cannot be controlled separatelywhen they are used in a flexible combination format, simultaneous operation of multi units format orany other such format since they will all operate at the same time.)The signal receiver has an address switch for signal reception, and the wireless remote control unithas an address switch for signal transmission.How to check theaddressesWhen the ADDRESS button on the wireless remote control unit is pressed, the current addressappears on the wireless remote control unit's display. The buzzer sounds if the addressdisplayed matches the signal receiver's address. (The buzzer always sounds if “ALL” appearsas the address display.)If “ALL” appears as the address display, operations can be performed irrespective of the signalreceiver's address. Point the wireless remote control unit at the signal receiver of the unit to beoperated, and send the signal.How to set thematching addressWireless remote control unit̉ s address setting1. When the ADDRESS button is held down for 4 or more seconds, “ ” lights on thewireless remote control unit's display, and the current address blinks.2. Each time the ADDRESS button is now pressed, the address changes by one setting in thefollowing sequence: ALL 1 2 3 6 ALL.Select the setting which matches the setting of the address switch in the operation area ofthe indoor unit to be operated.3. When the SET button is now pressed, the address stops blinking and lights instead, and itremains on the display for 5 seconds.The buzzer sounds if the setting matches the setting of the address switch in the operationarea of the indoor unit.When the batteries are replaced, the address setting returns to “ALL ”.NOTE2-5. Address Settings