Precautions10PrecautionsInstallation • Do not install the unit where it may be exposed to direct sunlight, near heating equipment, ornear air-conditioning vents as this may cause discoloration of the whiteboard.• Do not install the unit in strong sunlight or strong lighting. Proper copying may becomeimpossible.• Do not install the unit in locations where the temperature may change suddenly as this maydisable the unit’s ability to make copies.Whiteboard • Make thick and dark lines inside the scannablearea. Note that any writing inside the shaded area(on right) cannot be scanned.• Do not allow writing to remain on the whiteboard foran extended period of time as it will become harderto erase.• Do not erase with an overly dirty eraser (see page29).• Periodically wipe the whiteboard gently with a water-dampened cloth that has beenthoroughly wrung. (See page 29.)• Use magnets that are less than 7 mm ( 9/ 32" ) in height when attaching documents to thewhiteboard. Otherwise, the magnet may interfere when scanning the document.• When scanning, the shadow of a magnet may appear on images, blocking text or certainparts of a document/diagram.Markers andEraser• Use only the included or designated markers and eraser. (See page 38.) Use of accessoriesother than those included or designated (such as oil-based markers) may damage thewhiteboard or result in hard-to-erase markings.• Store markers horizontally as vertical storage may stop the ink from coming out.Scanner • Do not place hands on the top rail of this unit, as it may result in problems when scanning.• Do not place objects other than markers or erasers on the tray, as it may result in problemswhen scanning.• Keep both sides of the white balance area clear of objects or blemishes, if not, images willnot be scanned properly.Power Switch • When turn the power switch on after turning off, wait 2 seconds or more.Power Cord • When moving the unit, disconnect the power cord on both ends and coil it for transportationto prevent it from being damaged if stepped on or if it catches on something.USB • Do not connect a USB flash memory device to “USB Connector-A for Printer”.• Do not connect an external printer to “USB Connector-A for USB Flash Memory Device”.• The use of a USB hub is not recommended. We cannot guarantee that the unit will workproperly.• Use a shielded USB cable that is certified as logo by USB-IF.• Do not connect two or more Panasonic electronic boards to a computer. It may cause thecomputer operation to become unstable.Approx. 20 mm ( 25/ 32")Approx. 20 mm ( 25/ 32")Approx.20 mm(25/ 32")Approx.20 mm( 25/ 32")Scannablearea