Panasonic VL-GM201A Installation And Operation Manual

Contents

24Using the Unit{PUSH} mode (Push to talk mode)1 When a call is received from the door station, press {TALK}.2 Speak to the visitor.3 To end the conversation, press {TALK}.L The display will turn off.{AUTO} mode (Auto talk mode)This mode allows you to answer the call by voice. Speak a brief reply into (or toward) themonitor station, such as “Yes?” or “Hello?”. This reply is used to start {AUTO} mode; thevisitor will not hear your reply. The monitor station will beep to indicate {AUTO} mode hasstarted and you may then speak to the visitor.1 When a call is received from the door station, answer “Yes?” within 30 seconds.L A beep will sound to indicate that you can talk to the visitor (hands-free conversation).2 Speak to the visitor.3 To end the conversation, press {TALK}.Note:L Make sure you are within about 50 cm (20 inches) of the monitor station.L You can also answer the call by pressing {TALK}.L Your initial reply should be brief (less than 1 second), otherwise {AUTO} mode will not start.L If a visitor calls you, a loud, brief sound (such as a barking dog) may start {AUTO} modeeven though you have not replied by voice.{HOLD} mode (Hold to talk mode)1 When a call is received from the door station, press and hold {TALK} to speak to the caller.L A beep will sound and the Talk indicator will light.2 To listen to the visitor, release {TALK}.L The Talk indicator will turn off.3 To speak again, press and hold {TALK}.4 To end the conversation, tap {TALK}.Note:L Make sure you speak to the caller only while pressing {TALK} and release {TALK} whenyou have stopped speaking so that the caller can speak to you.