Panasonic Vericam 35 Operating Manual

Also see for Varicam HS: Operating guide

Contents

Panasonic Vericam 35 Operating Manual Manual pdf 36 page image

– 36 –Chapter 4 Video Recording and Color Grading — P2 cardP2 cardInserting a P2 cardWhen using the camera for the first time, be sure to set the time data beforehand. (page 31)Insert the expressP2 memory card into the main slot and the microP2 memory card into the sub slot.Main slot card access LEDSub slot 4Main slot 1Main slot 2Sub slot card access LEDSub slot 3Card slot coverFig. 1 Fig. 2 Fig. 3Main slot lock switchEject button1 Open the card slot cover. (Fig. 1)2 Insert a card into the card slot. (Fig. 2)f expressP2 memory cards (main slot)- Slide the main slot lock switch to the left to release the lock.- Insert the card with the logo facing up until the eject button pops out.- Press the eject button that pops up to the right.- Slide the main slot lock switch to the right to lock.f microP2 memory cards (sub slot)- Insert with the label facing up.3 Make sure that the card access LED is lit in orange or green. (Fig. 3) (page 37)When two P2 cards are inserted in the card slots, the P2 card with the smaller slot number will be recorded to first. Note, however, that regardless ofthe slot number, if a P2 card is inserted later, that P2 card will not be accessed until the previously inserted P2 card has been recorded to.f Example: When expressP2 memory cards are inserted in two slotsIf expressP2 memory cards are inserted into the two slots, the cards are used as expressP2 memory cards in the order of the slot number 1 → 2.However, if you remove the expressP2 memory card from slot 1 and then insert it again, recording to the expressP2 memory cards will take placein the order slot 2 → 1.The P2 memory card number to be recorded to is maintained even if the camera is turned off. When the camera is next turned on, recording can becontinued to the same P2 memory card as before the camera was turned off.4 Close the cover of the main slot or sub slot.@@ NOTEt The topmost slot on the sub slot side is for the SD memory card used for configuration, etc. Videos and other forms of data cannot be recorded.t Be sure to close the card slot cover in order to prevent dropping, dust, and static electricity.t Be sure to format P2 cards only on the camera.t Operation is not guaranteed if SDHC/SDXC memory cards other than microP2 memory cards are used in the sub slot.t If a microP2 memory card is inserted slowly, [FORMAT ERROR!] or [NOT SUPPORTED!] may be displayed. In such a case, insert the card again.