– 96 –Chapter 10 Menu Operations — Menu listItem Description of settings[USER CLIP NAME] Sets data to be recorded to [USER CLIP NAME].(When [RECORD] is [ON])[TYPE1]: Records setting values of the loaded data.[TYPE2]: Records the loaded data and counter value.(When [RECORD] is [OFF])[TYPE1]: Records the same value as [GLOBAL CLIP ID].[TYPE2]: Records the same value as [CLIP NAME].f Factory setting: [TYPE1][PROPERTY] Checks loaded metadata. This cannot be modified.[COUNTER RESET] Resets the counter value when [USER CLIP NAME] is set to [TYPE2].[VF SDI SETTINGS]Sets the display content of the output video from the viewfinder and terminal.Item Description of settings[MARKER] [SW] Sets whether to display markers in the output from the terminal and terminal.[ON], [OFF]f Factory setting: [ON][CENTER MARKER] Switches the center marker.[1]: + (large)[2]: Open center (large)[3]: + (small)[4]: Open center (small)[OFF]: Does not display.f Factory setting: [1][SAFETY MARKER] Selects the type of frame for the safety zone marker.[1]: Box[2]: Corners[OFF]: Does not display.f Factory setting: [OFF][SAFETY AREA] Sets the size of the safety zone marker.[80] - [100%] (1% step, fixed aspect ratio)f Factory setting: [90%][FRAME MARK] Enables/disables frame marker.[ON], [OFF]f Factory setting: [OFF][FRAME SIG] Sets frame marker aspect ratio.[1.33:1], [1.44:1], [1.56:1], [1.78:1], [1.85:1], [2.35:1]f Factory setting: [2.35:1][FRAME LEVEL] Sets the level of the outside of the frame marker.[0%] - [100%] (10% step)f Factory setting: [100%][MARKER & CHAR LVL] Sets the marker and character luminance.[50%], [60%], [70%]f Factory setting: [50%][USER BOX] Sets whether to display/hide the user box display.[ON], [OFF]f Factory setting: [OFF][USER BOX WIDTH] Sets the width of the user box.[1]…[100]f Factory setting: [13][USER BOX HEIGHT] Sets the height of the user box.[1]…[100]f Factory setting: [13][USER BOX H POS] Sets the horizontal position of the center of the user box.[−50]…[50]f Factory setting: [0][USER BOX V POS] Sets the vertical position of the center of the user box.[−50]…[50]f Factory setting: [0][ZEBRA] [ZEBRA MASTER SW] Sets whether to superimpose the zebra signal on the output from the terminal and terminal.[ON], [OFF]f Factory setting: [OFF][ZEBRA2 SW] Enables/disables zebra pattern 2 and selects [SPOT].[ON], [SPOT], [OFF]f Factory setting: [OFF][ZEBRA1 DETECT] Sets the detection level of zebra pattern 1.[0%] - [109%]f Factory setting: [80%][ZEBRA2 DETECT] Sets the extraction level of zebra pattern 2.[0%] - [109%]f Factory setting: [100%]
