Advanced (Recording pictures)- 100 -When [AUTO REGISTRATION] is set to [ON], the registration screen will displayautomatically after taking a picture of a face that has a high number of appearances.• Registration screen is displayed after approximately 3 pictures. (It is not counted when[BURST] and Auto Bracket is set.)• It may be extremely hard to recognise only with [AUTO REGISTRATION], so register the faceimages with [FACE RECOG.] in the [REC] Mode menu beforehand.∫ Registering from the automatic registration screen1 Press 3 to select [YES] and then press [MENU/SET].• If there are no registered persons, proceed to step 3.• Selection screen is displayed again when [NO] is selected, andwhen [YES] is selected with 3, [AUTO REGISTRATION] will beset to [OFF].2 Press 3/4 to select [NEW PERSON] or[ADDITIONAL IMAGE] and then press [MENU/SET].• After additionally registering or changing a face image, the screen returns automatically tothe recording screen.3 Perform the operation in Step 6 and following in “Registering face image of newperson”.Note• If the registration screen will not display, it may display easier by recording in the sameconditions or with the same expressions.• If a face is not recognised even though it is registered, it will make the recognition easier byregistering the person again using the [FACE RECOG.] in the [REC] Mode menu in thatenvironment.• If the registration screen is displayed for a person that is already registered, it will make therecognition easier by additionally registering.• It may make recognition harder when a picture recorded with flash is registered.Auto RegistrationItem Description of settings[NEW PERSON] • A list of registered people is displayed when there are 6 peoplealready registered. Select the person to be replaced.[ADDITIONAL IMAGE]To additionally register a face image for a registered person.Press 3/4/2/1 to select the person to whom you wishadd the picture, and then press [MENU/SET].• If 3 images have already been registered, the picturereplacement screen will appear. In this case, select the pictureyou wish to replace.
