Panasonic Viera TC-P50VT25X Operating Instructions Manual

Also see for TC-P50VT25X: Operating instructions

Contents

Panasonic Viera TC-P50VT25X Operating Instructions Manual Manual pdf 22 page image

22Basic features of 3D EyewearThis product cannot be used as sunglasses.This product can be worn over vision correction glasses.Optional AccessoryTY-EW3D10U (as of April, 2010)Visit http://www.panasonic.com/ for more information.Part names and functionsAccessories3D Eyewear (1)3D Eyewear case (1)Specialized band (1)If the end of the specializedband is loosened, make a loopat the end as shown in theabove figure and smooth thetwisted rubber before using.Nose pad (1 of each)A BUse either nose pad A or Bfor your preference.If you put the 3D Eyewearon vision correctionglasses, the nose padis recommended to beremoved.Viewing 3D images on TVYou can enjoy 3D images by wearing the 3D Eyewear supplied with this TV and to view 3D broadcasts and 3D image software.Infra-red receiverReceives infra-red signals from the television.The liquid crystal shutter open/close timing is controlled by receiving infra-redsignals from the television, which provide 3D expression of the images.Battery caseFitting the batteries (p. 23)When using for the first time,remove the insulating sheet.(p. 23)Nose pad installation section3D Eyewear inner section (p. 23)Specialized band can beattached here. (p. 23)Liquid CrystalShutterControls the images for3D viewing.The left and right liquidcrystal shutters arealternately openedand closed in time withthe left side and rightside images that arealternately displayedon the television toachieve the 3D effect.Power button(bottom side of 3D Eyewear)Switches on the 3D Eyewear power.Indicator lampPower buttonPress and hold the power button for approximately1 second to switch the power on, and the Indicatorlamp lights for approximately 2 seconds. To switchthe power off, press and hold the power button forapproximately 1 second. (The Indicator lamp flashes 3times, then the power switches off.)SpecificationsLens type Liquid Crystal Shutter typeDimensionsWidth: 6.97” (177 mm)Height: 1.82” (46 mm)Overall length: 6.86” (174 mm)Batteries(duration)Coin-shaped lithium battery CR2032(approx. 75 hours in continuous use)Usage temperaturerange32 °F – 104 °F(0 °C – 40 °C)Power supply DC 3 VMass (including batteries) 0.14 lb (63 g)Viewing range* Transmitter for 3D EyewearWithin 3.2m from front surface(Within ±35° horizontal, ±20° vertical)Materials Main body: resinLens section: Liquid crystal glass* Viewing range: The location of the 3D Eyewear transmitter (p.13)