Panasonic Viera TH-37PR10 Operating Instructions Manual

Also see for TH-42PR10U: Operating instructions Service manual Manual de instrucciones

331/2PCOFFSTANDBY SAVE OFFPOWER MANAGEMENT OFFAUTO POWER OFF OFFOSD LANGUAGE ENGLISH (US)COMPONENT/RGB-IN SELECTRGBINPUT LABELSIGNALPOWER SAVESET UP3D Y/C FILTER (NTSC)COLOR SYSTEMSIGNALONAUTO3 : 2 PULLDOWNPanasonic AUTO (4 : 3)OFFNORMAL[ VIDEO ]VIDEO NR OFF3D Y/C FILTER (NTSC)COLOR SYSTEMSIGNALONAUTO3 : 2 PULLDOWNPanasonic AUTO (4 : 3)OFFNORMAL[ VIDEO ]VIDEO NR OFFSYNCVIDEO NRSIGNALAUTOH-FREQ.V-FREQ.kHzHz33.860.0[ RGB ]3 : 2 PULLDOWN OFFOFF3 : 2 PULLDOWNVIDEO NRSIGNALOFFOFF[ COMPONENT ]3 : 2 PULLDOWNVIDEO NRSIGNALOFFOFFH-FREQ.V-FREQ.kHzHz33.860.0[ Digital ]3:2 PULLDOWN / VIDEO NRCOLOR SYSTEM / Panasonic AUTOSelect SIGNAL from the “SET UP” menu during VIDEO (S VIDEO) inputsignal mode.(“SIGNAL [VIDEO]” menu is displayed.)SET UP for Input SignalsPress to select the “COLOR SYSTEM” or “PanasonicAUTO”.Press to select each function.If the image becomes unstable:With the system set on Auto, under conditions of lowlevel or noisy input signals the image may in rarecases become unstable. Should this occur, set thesystem to match the format of the input signal.Press to select 3:2PULLDOWN or VIDEO NR.Press to set ON/OFF.Press to exit from adjust mode.3:2 PULLDOWN: When ON, the display attempts to reproduce a more natural interpretation of sources such as moviepictures, which are recorded at 24 frames per second.If the picture is not stable, turn the setting to OFF.Notes:When ON, this setting only affects the following signal input:• NTSC / PAL signal input during “VIDEO (S VIDEO)” input signal.• 525i(480i) 625i(575i), 1125(1080)/60i signal input during “COMPONENT” input signal.VIDEO NR: Automatically reduces unwanted picture noise.Note:VIDEO NR cannot be adjusted while a PC signal is being applied.12Press ACTION ( ) button1/2PCOFFSTANDBY SAVE OFFPOWER MANAGEMENT OFFAUTO POWER OFF OFFOSD LANGUAGE ENGLISH (US)COMPONENT/RGB-IN SELECTRGBINPUT LABELSIGNALPOWER SAVESET UPPress ACTION ( ) buttonNote:Panasonic AUTO does not function when BNC Dual Video Terminal Board (TY-FB9BD) is used.Mode FunctionCOLOR SYSTEM Set the color system to match the input signal. When selecting “AUTO”, the color system is automaticallyselected from NTSC/PAL/SECAM, however, M.NTSC signal is not displayed properly depending onthe attached terminal board. To display M.NTSC signal, select “M.NTSC” in COLOR SYSTEM.AUTO SECAM M.NTSC NTSCPALPanasonic AUTO(4 : 3 )Set to “NORMAL” to view 4:3 images in an unchanged format when Panasonic AUTO isselected. If you would like to view 4:3 images in Just format, set to “JUST”.