Panasonic Viera TH-42PWD5 Operating Instructions Manual

29ADVANCED SETTINGSHelpful Hint ( / NORMALIZE Normalization)Note:In PICTURE, there is nor a noticeable change even when contrast is increased with a bright picture or reduced with a darkpicture.PICTURE AdjustmentsItemPICTUREBRIGHTNESSCOLORTINT(NTSC only)SHARPNESSEffect AdjustmentsLess MoreDarker BrighterReddish GreenishAdjusts the proper picture contrast.Adjusts for easier viewing of dark picturessuch as night scenes and black hair.Adjusts color saturation.Adjust for natural flesh tones.Adjusts picture sharpness.Notes:(1) “COLOR” and “TINT” settings cannotbe adjusted for “RGB” and “PC” inputsignal modes.(2) You can change the level of eachfunction (PICTURE, BRIGHTNESS,COLOR, TINT, SHARPNESS) for eachPICTURE menu.(3) The setting details for STANDARD,DYNAMIC and CINEMA respectivelyare memorized separately for eachinput mode (VIDEO (S VIDEO),COMPONENT, RGB and PC).(4) The “TINT” setting can be adjusted forNTSC signal only during “VIDEO(S VIDEO)” input signal.Less MoreLess MoreNItemBLACKEXTENSIONW/B HIGH RW/B HIGH BW/B LOW RW/B LOW BGAMMAEffectLess MoreLess MoreLess MoreLess MoreDetailsAdjusts the dark shades of the image in gradiation.Adjusts the white balance for light red areas.Adjusts the white balance for light blue areas.Adjusts the white balance for dark red areas.Adjusts the white balance for dark blue areas.2.0 2.2 2.5Notes:(1) Carry out “W/B” adjustment as follows.A Adjust the white balance of the bright sections using the “W/B HIGH R” and “W/B HIGH B” settings.B Adjust the white balance of the dark sections using the “W/B LOW R” and “W/B LOW B” settings.C Repeat steps A and B to adjust.Steps A and B affect each other’s settings, so repeat each step in turn to make the adjustment.(2) The adjustment values are memorized separately for each input mode (VIDEO(S VIDEO), COMPONENT, RGB and PC).(3) The adjustment range values should be used as an adjustment reference.Less MoreDown UpOn the remote control unit, while the “ADVANCED SETTINGS” menu is displayed, if either the N button is pressed atany time or the (ACTION button) is pressed during “NORMALIZE”, then all adjustment values are returned to thefactory settings.