Auto Tuning15Auto TuningSearch and store TV channels automatically.● These steps are not necessary if the setup has been completed by your local dealer.● Please complete connections (p. 12 - 14) and settings (if necessary) of the connected equipment before startingAuto Tuning. For details of settings for the connected equipment, read the manual of the equipment.1 Plug the TV into mains socket and switch on● Takes a few seconds to be displayed.● If the red LED shows on the TV, press the Standby On / Off switch on theremote control.2 Select your areaNew South Wales / Australian Capital TerritoryVictoriaQueenslandSouth AustraliaWestern AustraliaNorthern TerritoryTasmaniaSelect State / Territory selectset3 Select the mode to tuneTV Signal SelectionDigital TVAnalogue TVStart Auto Tuningselecttune / skip tuning: tune (search for the available channels): skip tuning4 Select [Start Auto Tuning]TV Signal SelectionDigital TVAnalogue TVStart Auto Tuningselectaccess● Auto Tuning will start to search for TV channels and store them.The stored channels and sorted channel order vary depending on the area,broadcasting system and conditions of signal reception.CH 0 75CH 6 69626262622933101010--CBBC ChannelBBC Radio WalesE4Cartoon Nwk10SearchingAuto TuningDigital TV ScanAnalogue TV ScanThis will take about 6 minutes.RF Ch Channel Name TypeDigital TVDigital TVDigital TVDigital TVAnalogue TVAnalogue TVQualityDigital TV: 4 Analogue TV: 25 Setup the network connectionSetup the network connection to enable the network service functions such as VIERAConnect, etc. (p. 18, 61).● Please note that this TV does not support wireless public access points.● Ensure the network connections (p. 14) and network environment are completedbefore starting setup.Select the network typeNetwork SetupSelect Wired or WirelessWired Wireless Set later[Wired] “Wired connection” (p. 14)[Wireless] “Wireless connection”(p. 14)selectaccess● To setup later on or skip this stepSelect [Set later] or