- 124 -Note● TV Guide may also be used to set timer event.Watching > TV Guide > Timer Programming● Timer Programming can store up to 15 events.● Timer Programming only works reliably if correct time information isreceived via the signal from the broadcaster or service provider.● For recording using Timer Programming, the TV must be either on or inStandby. For reminders to be displayed, the TV must be on.● Depending on the progress of recording, analogue channel may not beselected.● Recording an encrypted (copy-protected) programme may not be possible.● 2 minutes before the start time, a reminder message may appear if youare watching TV.– To remove the message and start the programming, press OK.– To cancel the programming, press EXIT.● LED will turn to orange in Standby mode if Timer Programming is set.● Reminder messages will remain displayed until one of the followingoccurs:– You press OK to view the programme or EXIT to cancel the reminder.– The timer event that the reminder is set for ends.● “!” identifies that three or more timer events are overlapped. USB HDDRec. is given priority over Reminder. As for the overlapped recordingevents, the first event starts and finishes as programmed. The next eventcan then start.● The recording of Timer Programming may automatically change thechannel to the programmed channel a few seconds before the start time.● The recording of Timer Programming will be performed even if the TV is inRewind LIVE TV recording. In this case, Rewind LIVE TV recording will becancelled.Recording > Recording current programme > Rewind LIVE TV● For more information of the USB HDDRecording > Technical information
