Panasonic Viera TX-L32E30E Operating Instructions Manual

Also see for Viera TX-L42E30E: Service manual

Contents

Accessories / OptionsQuick Start Guide7Attaching the pedestalWarningDo not disassemble or modify the pedestal.• Otherwise the TV may fall over and become damaged, and personal injury may result.CautionDo not use any pedestal other than the one provided with this TV.• Otherwise the TV may fall over and become damaged, and personal injury may result.Do not use the pedestal if it becomes warped or physically damaged.• If you use the pedestal while it is physically damaged, personal injury may result. Contact your nearest Panasonic dealerimmediately.During assembly, use only screws supplied and make sure that all screws are securely tightened.• If sufficient care is not taken to ensure screws are properly tightened during assembly, the pedestal will not be strong enoughto support the TV. It might fall over and become damaged and personal injury may result.Ensure that the TV does not fall over.• If the TV is knocked or children climb onto the pedestal with the TV installed, the TV may fall over and personal injury mayresult.Two or more people are required to install and remove the TV.• If two or more people are not present, the TV may be dropped, and personal injury may result.A Assembly screw (4)M5 × 15B Assembly screw (4)M4 × 30C Bracket• TBL5ZA3017( )TX-L32E30ETX-L37E30E• TBL5ZA3014(TX-L42E30E)D Base• TBL5ZX0140 (TX-L32E30E)• TBL5ZX0144 (TX-L37E30E)• TBL5ZX0149 (TX-L42E30E)1 Assembling the pedestalUse the assembly screws A to fasten the bracketC to the base D securely.• Make sure that the screws are securelytightened.• Forcing the assembly screws the wrong waywill strip the threads.ADCFrontHold the bracket not tofall over2 Securing the TVUse the assembly screws B to fasten securely.• Tighten the four assembly screws loosely at first, then tightenthem firmly to fix securely.• Carry out the work on a horizontal and level surface.BBFoam mat or thick soft clothInstalling / removing remote’s batteries1Pull openHookCaution• Incorrect installation may cause battery leakage and corrosion, resultingin damage to the remote control.• Do not mix old and new batteries.• Replace only with same or equivalent type. Do not mix different batterytypes (such as alkaline and manganese batteries).• Do not use rechargeable (Ni-Cd) batteries.• Do not burn or break up batteries.• Do not expose batteries to excessive heat such as sunshine, fire or the like.• Make sure you dispose of batteries correctly.• Ensure batteries are replaced correctly, there is danger of explosion andfire if battery is reversed.• Do not disassemble or modify the remote control.2Note the correctpolarity (+ or -)Close