Panasonic Viera TX-L32ET5B Operating Instructions Manual

Also see for Viera TX-L32ET5B: Service manual

Contents

Panasonic Viera TX-L32ET5B Operating Instructions Manual Manual pdf 100 page image

FAQs | On-screen messages100Problem Causes / ActionsOtherThe TV does not switch on ● Check the mains lead is plugged into the TV and the socket outlet.The TV goes into Standbymode● Auto power standby function is activated. (p. 11)● The TV enters Standby mode about 30 minutes after analogue broadcastingends.The remote control doesnot work or is intermittent● Are the batteries installed correctly? (p. 8)● Has the TV been switched on?● The batteries may be running low. Replace them.● Point the remote control directly at the front of the TV (within about 7 m and a30 degree angle of the front of the TV).● Situate the TV away from sunshine or other sources of bright light not to shineon the TV’s remote control signal receiver.Parts of the TV becomehot● Even when the temperature of parts of the front, top and rear panels has risen,these temperature rises do not cause any problems in terms of performance orquality.The LCD panel movesslightly when it is pushedwith a fingerClattered sound might beheard● There is some flexibility around the panel to prevent damage to the panel.● The panel might move slightly when it is pushed with a finger, and clatteredsound might be heard. This is not a malfunction.Overcurrent errormessage appears● The connected USB device might cause this error. Remove the device and turnthe TV off with Mains power On / Off switch, then turn it on again.● Check foreign objects are not inside the USB port.An error message appears● Follow the message’s instructions.● If the problem persists, contact your local Panasonic dealer or the authorisedservice centre.On-screen messagesMessage Meaning / ActionAll tuning data will be erased ● [Shipping Condition] will erase all tuning data. (p. 55)Are you sure ? ● Confirm correct operation.Are you sure you want todelete this timer ?Press OK to delete timer.Press RETURN to return.● Confirm correct operation.Bad signal● The signal is weak. Check the aerial is plugged in properly. It may benecessary to have an aerial installer check the signal and aerial alignment.● Reset channels. (p. 48)Child Lock is active!Press OK to enter PIN.● The selected channel is locked in Child Lock (p. 54). You must enter the PINnumber before the channel will be displayed.External Recording Due toStart● This message will appear 2 minutes before timer programming event forexternal recording due to start.Feature not available.● It is not possible to record from AV2 (COMPONENT) or HDMI. Connect therecorder to the TV using a fully wired SCART cable for recording from the TVtuner.● Confirm Q-Link or VIERA Link settings. (p. 78 - 81)Feature not available.Press OK to view how it works.● The selected feature on VIERA TOOLS is not available. Press the OK button toview the demonstration to explain how to use it.Found new software version∗∗∗.Press OK to start update (maytake over 40 mins) or pressEXIT to ignore and you canupdate when TV is in standby● There is a new software available.