Quick Start Guide7Accessories / OptionsAttaching the pedestalWarningDo not disassemble or modify the pedestal.Otherwise the TV may fall over and become damaged, and personal injury may result.CautionDo not use any other TV and displays.Otherwise the TV may fall over and become damaged, and personal injury may result.Do not use the pedestal if it becomes warped or physically damaged.If you use the pedestal while it is physically damaged, personal injury may result. Contact your nearest Panasonic dealer immediately.During assembly, use only screws supplied and make sure that all screws are securely tightened.If sufficient care is not taken to ensure screws are properly tightened during assembly, the pedestal will not be strong enough to support the TV. It might fall over and become damaged and personal injury may result.Ensure that the TV does not fall over.If the TV is knocked or children climb onto the pedestal with the TV installed, the TV may fall over and personal injury may result.Two or more people are required to install and remove TV.If two or more people are not present, the TV may be dropped, and personal injury may result.Assembly screw (4)XSS4+16FNK Assembly screw (4)XYN4+F12FJK Bracket (1)TUX0EA004 (TX-LF32G20S)TUX0E198 (TX-LF37G20S)TUX0EA007 (TX-LF42G20S)Base (1)TBL0E0119 (TX-LF32G20S)TBL0E0120 (TX-LF37G20S)TBL0E0121 (TX-LF42G20S)Assembling the pedestalUse the four assembly screws to fasten the bracketto the base securely.Make sure that the screws are securely tightened.Securing the TVUse only the supplied assembly screws to fastensecurely.Make sure that the screws are securely tightened. Carry out the work on a horizontal and level surface.ACDFrontB BFoam mat or thick soft clothAdjust the panel to your desired angleEnsure that the pedestal does not hang over the edge of the base even if the TV swivels to the full rotation range. Do not place any objects or hands within the full rotation range.15°ab15°(View from the top)TX-LF32G20S a: 358 mm / b: 230 mmTX-LF37G20S a: 399 mm / b: 296 mmTX-LF42G20S a: 450 mm / b: 322 mmSet the mark at the centre as illustrated, toensure full degree rotation in either direction.