Panasonic Viera TX-P46Z1E Operating Instructions Manual

Contents

12Connecting the Display Unit and the Tuner BoxPlease ensure that the unit is disconnected from the mains socket before attaching or disconnecting any leads.Conditions■ If you are going to place the Tuner Box close to or under the Display Unit, it is recommended to connect them●using the supplied HDMI cable.If your installation layout is not suitable for using the Wireless Unit (Example 2), connect them using thesupplied HDMI cable.Example 1 (below)You can place the Tuner Box and the Display Unit in a flexible way using the Wireless Unit (not using any●cables between the Display Unit and the Tuner Box). To use wireless connection between the Display Unit andthe Tuner Box, ensure that the Wireless Transmitter and the Wireless Receiver are positioned to face eachother without any obstructions.Example 2 (p. 12 and p. 13)Example 1■ Tuner BoxTU-Z100ER● HDMI cableK1HY19YY0004●AUDIOINCOMPONENTAUDIOOUTDIGITALAUDIO OUT HDMI 1PBYPRLRLRHDMI 2 HDMI 3ABRear of the Display UnitRear of the Tuner BoxMains leadAC 220-240 V50 / 60 Hz MainsleadTuner Box orK1HY19YY0006●HDMI cable3.0 mBasic ConnectionExample 2■ The Wireless Unit uses 60 (59.40 - 61.56) GHz frequency band. Do not use the Wireless Unit near the●equipment using the same frequency band to avoid the interference.It may take a while to change the input mode when using the Wireless Unit. To resolve this, use the supplied●HDMI cable to connect the Display Unit and the Tuner Box. Example 1 (above)Picture and sound may be interrupted or lost completely depending on the positioning of the Wireless●Transmitter or obstacles (furniture, AV equipment, rack, rack door, etc.) between the Wireless Transmitterand the Wireless Receiver. To resolve this, change the installation layout to avoid any obstacles between theWireless Transmitter and the Wireless Receiver.Transmission Range of the Wireless Unit : Available area to place the Wireless Transmitter40°5°WirelessTransmitterWirelessTransmitterView from the sideView from the top10 m10 m5 m5 m80° 80°WirelessReceiverDisplayUnitDisplay UnitTuner BoxTuner BoxWirelessReceiver45°45°5 m5 mAdjust the angle of the●Wireless Transmitter toface the Wireless Receiver.CautionDo not place the Wireless Unit in the following locations to avoid poor signal condition or unit failures.● Location subject to be high temperature (near the heater, etc.)•Location with poor air circulation (at the end of a closed rack, etc.)•Keep the Wireless Unit away from the devices such as wireless LAN, microwaves, mobile phones or other●electric equipment to avoid radio wave interference. Otherwise malfunction or slow response may occur.NoteThe range may be shortened depending on the obstacles, the surrounding environment or building structure.●Ensure the Wireless Transmitter is facing the Wireless Receiver.●