Panasonic WH-UD05JE5 Service Manual

Also see for WH-ADC0309J3E5UK: Installation manual

Contents

Panasonic WH-UD05JE5 Service Manual Manual pdf 77 page image

7712.2.7.2 Remote Controller Wiring12Terminal for Remote Controller wiringRemote ControllerTank UnitRemote Controller w(field supply)iring• No polarity Remote Controller cable shall be (2 x min0.3 mm2), of double insulation PVC-sheathed orrubber sheathed cable. Total cable length shall be50 m or less. Be careful not to connect cables to other terminalsof Tank Unit (e.g. power source wiring terminal).Malfunction may occur. Do not bundle together with the power sourcewiring or store in the same metal tube. Operationerror may occur.12.2.7.3 Remove The Remote ControllerFrom Tank Unit Remove the top case from the bottom case.BottomcaseFlat-bladescrewdriverInsert thedriver andslightly turn. Remove the wiring between Remote controllerand Tank Unit terminal.Disconnect theRemote controllerwiringClaw(2 places)12.2.7.4 Mounting The RemoteControllerFor exposed typePreparation: Make 2 holes for screws using a driver.UPCut here witha nipper andremove the burrwith a file.Mount the top case.• Align the claws of the topcase and then align the clawsof the bottom case.Hole for screwScrew(field supply)Claw (2 places)Pass throughthe holeBottom case(Back side)Top case(Back side)Remote controller terminal boardRemove the coating. Approx. 6 mmRemove the sheath. Approx. 180 mm.Make sure the wiring connection is in thecorrect direction.Clamper(field supply)Claw (2 places)Wall to whichthe remotecontrollerfixedisMount the bottom case tothe wall.Connect the remote controlwiring• Arrange the wires along the grooveof the case.For embedded typePreparation: Make 2 holes for screws using a driver.UPAvoid the wirebeing caught.Mount the top case.• Align the claws of the topcase and then align the clawsof the bottom case.Hole forscrewScrew(field supply)Claw (2 places)Bottom case(Back side)Top case(Back side)Remote controllerterminal boardRemove the coating.Approx. 6 mmMake sure the wiringconnection is in the correctdirection.Claw (2 places)Mount the bottom caseto the wall.• Pass the wire through the holein the centre of the bottom case.Connect the remotecontrol wiring