Panasonic WJ-AV20 Operating Instructions Manual

Contents

Panasonic WJ-AV20 Operating Instructions Manual Manual pdf 11 page image

11BEFORE STARTING OPERATIONccSTEP2 STEP3DIALMEMORYCALLREDIALDELETEESC AUDIO MUTEMENUALM MEMORYENTERTELE WIDE AF NEAR FARSTEP1Remote Controller WV-CU201 2 34 5 67 8091 2 3 4 5#VIDEOAUTO/MANUALM ACKONE TOUCH DIALLINE1 LINE2 RING.VOLPOWERONOFFREMOTE3When you are not using the AV Codec for a long period oftime, press the power switch off and remove the power plugfrom the AC outlet. Switching Power ON/OFF1Connect the Remote Controller to the AV Codec.Connect the WV-CU20E remote controller to the controller jack or port onthe front or rear of the AV Codec.2Press the power switch on.• When power is switched on, the power indicator lights up.• The blue screen appears first after power is switched on. The present timeis shown on the monitor in about 10 seconds, and the AV Codec is in astandby state and is ready for operation.CLOCK01/01/99 MON 00:00:00PLEASE SET DATE.TIME IN CLOCKSETUP MENU 410.VIDEO1 01/01/99 00:00:00TITLEConnect the remotecontroller to the AVCodec with the cablesupplied with the con-troller. (Use the 6-con-ductor DIN cable toconnect it to the frontof the AV Codec, orthe 6-conductor mod-ular cable to connectit to the rear.)Normally, keep the power switchin the ON position during use.When the power switch is pressedoff, calls cannot be originated orreceived. Normally, keep the powerswitch in the ON position and installthe supplied switch protector overthe power switch.SWITCHPROTECTORdStandby screen appears in about 10seconds.If the date and time are incorrect, thencorrect them using the setup menu.