Panasonic WJ-AV20 Operating Instructions Manual

Contents

Panasonic WJ-AV20 Operating Instructions Manual Manual pdf 22 page image

22OPERATION DURING COMMUNICATIONNormally, video and audio are sent to the control site according to the settings at the remote sites during communication. Thefollowing items can be remote controlled from the control site during communication.(1) Switching video transmitting mode (auto/manual)(2) Switching remote site (transmitter) video input, preset, trigger output(3) Combination camera operationPan/tilt, zoom and focus control and calling preset numbers (1 to 8) if a combination camera is connected(4) Switching view points (1 to 8)(5) Video quality selectionQuality of video sent from the remote site can be changed on the menu. Read the description of item [520 VIDEOMOTION MODE] on the menu [500 TRANS. CONTROL/SETUP].(6) Interruption of audio transmission from the control site (receiver) to the remote site, or request for resuming transmission(7) Switching receiving video, or local site videoWhen the numeric button [0] on the controller is pressed, then receiving the video and local site video can be alternatelychanged. Switching Video to TransmitSTEP2 STEP3DIALMEMORYCALLREDIALDELETEESC AUDIO MUTEALM MEMORYSTEP1Remote Controller WV-CU201 2 34 5 67 8091 2 3 4 5#VIDEOAUTO/MANUALM ACKONE TOUCH DIALEach time the VIDEO AUTO/MANU button is pressed during communication, ON(automatic switching) and OFF (manual switching) are alternately selected.Communication starts in ON mode. Automatic SwitchingThe view points can be automatically switched to monitor the video according tothe sequential scan and alarm input settings.When auto mode is selected, the video is switched according to the menu settings[470 SEQ. SCAN] of the remote sites.To use automatic switching by sequential scan, the item [SEQ SCAN] on menu [470SEQ. SCAN] must be set to ON at the remote site AV Codecs. Sequential scan isinterrupted when the following steps are taken.• Pressing a numeric button (Selecting a view point by manual switching)• Switching view points by alarm inputSequential dialing returns when the auto reset time is over after interruptingsequential scan.Each time this buttonis pressed, auto andmanual modes arealternately selected.View point video isselected.Receiving videoand local site videoare switched fromone to the other.What Is a View Point?A view point is a combination of video input switching, trigger output, and combination camera preset operation. Set avideo input, preset position and trigger output for each point (number) on the menu [430 VIEW POINT SETUP]. Manual SwitchingSequential scan and view point switching by alarm input are withheld during manual switching. To manually switch the videoto monitor, press the numeric button (1 to 8) for the desired view point number of the monitoring remote site. The view pointscan be switched from one to another by pressing the [ ] button.