Panasonic WJ-HD100 Operating Instructions Manual

Also see for WJHD100 - DIGITAL DISC RECORDE: Specifications Operating instructions Specification sheet Operating instructions

Panasonic WJ-HD100 Operating Instructions Manual Manual pdf 44 page image

45DAYLIGHT SAVINGSOFF, INT or EXT selectableOperate LCD Button.Item WV-CU360WJ-HD100 NoteDAYLIGHTSAVINGSSHIFTSETUPFUNCTION31Timer REC ModeSelection SHIFTSETUPFUNCTIONButton Lock OFF Operate LCD Button.Operate LCD Button.Button Lock ON SHIFTSETUPFUNCTION3 1SHIFTSETUPFUNCTION3 0 SERIES RECORDINGMore than one Digital Disk recorder (unit) can be connected in series to increase the total disk capacity. Recording continuesfrom the start of the next recorder’s disk when the recording unit reaches its disk end. There are two ways of series recording:loop connection recording and series connection recording. Refer to page 12 and 13 of the Operating Instructions for connec-tions.Loop Connection: Recording continues endlessly.Series Connection: Recording continues until the final unit reaches its disk end.Recording starts and stops as described below.Manual: Pressing the REC and STOP button will start and end recording.Internal Timer: Recording starts and ends according to the preset START and END time.Notes:• Alarm recording interrupts loop or series recording for the preset DURATION if the connected sensor or VMD on thecurrent unit turns on. The unit reverts to loop or series recording after the duration.• Alarm recording is carried out on a unit basis. The next unit will not continue alarm recording even when recording onthe previous unit has ended before the duration has elapsed. Loop Connection RecordingSetupYou need to set up each unit on the individual setup menu, because the settings made for one unit will not affect the otherunits.1. Set DISK END MODE to SERIES for all units in each setup menu. (See page 25.)2. Set INTERNAL TIMER REC for all units in each setup menu if you wish to preset specific times (See page 29). Skip thisstep if you are not using the timer function.3. Close all setup menus.Operating Procedures1. Enter the prompt mode.The FULL indicators on all units will light when the setup menu is closed or the power is turned on right after the setup. Atthe same time the monitor displays a blinking “HDD FULL” message to prompt you to designate the first unit.