Indication56H-METER Press the ALARM RESET button to can-cel the warning status. The unit will be inthe error half-reset/error reset condition.Contact the dealer to replace the harddisk.Warning The set time for the HOUR METER haspassed. (Refer to page 94.)It may be reaching the end of the harddisk’s lifetime.W-ERRORSMARTALT-*ERROR/WARNINGS• The "error" statusWhen a fatal error (one that might cause the system to go down) has occurred, the ERROR indicator will blink red and theerror indication will be displayed on the monitor 2.• The "warning" statusWhen an error (even though it has not caused the system trouble yet, but which may become a fatal error) has occurred,the ERROR indicator will blink orange.• When the buzzer sounding duration has passed from the error occurrence or the ALARM RESET button is pressed, theerror indication will disappear and the blinking ERROR indicator will light steadily. (Error half-reset)If the error is eliminated, the ERROR indicator will go off when the ALARM RESET button is pressed while the ERROR indi-cator is lit. (Error reset)Status Description SolutionErrorErrorWarningRecorded image has been altered.Playback will be paused.Failed to write data on the HDD.The hard disk may be malfunctioningand may not work correctly.Press the ALARM RESET button to can-cel the error status. The unit will be inthe error half-reset/error reset condition.Press the PLAY/PAUSE button to resumeplayback.Press the ALARM RESET button to can-cel the error status. The unit will be inthe error half-reset/error reset condition.When the "W-ERROR" indication is dis-played frequently, contact the dealer toreplace the hard disk drive.Press the ALARM RESET button to can-cel the warning status. The unit will be inthe error half-reset/error reset condition.Contact the dealer to replace the harddisk.ERROR indicator on thefront panelBlinks Lights steadily OffBuzzer Sounds (when it has beenset)Stops StopsError display area on themain barDisplays Displays Does not displayThe error output (pin no.18)of the ALARM/CONTROLconnectorProblem mailError log Filed – –OutputsTransmitted (When it hasbeen set)Does not output–Does not output–At an error occurrence In the error half-resetconditionIn the error reset condition